8-Button Module - Waveshare 3678

Module with a button and red LED backlight. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 111020044

Keyboard module with five colored buttons. The board is equipped with a Gravity connector and has an analog output. Powered with the voltage of 3.3 V or 5 V. DFRobot DFR0075

Module with a button and yellow LED backlight. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 111020045

Conductivity Sensor Switch DFRobot is a touch button that allows you to change the sensor output status by connecting terminals (positive and negative) using metal, human body or fruit and plants. It is powered by 3.3 ... 5 V. DFRobot SEN0223

Touch keyboard module with 8 buttons and one line sensor (slider)

Touch keyboard module with 8 buttons based on the TTP226 chip. It is equipped with a connector with derived signals and LEDs that indicate the state of each button

Keyboard module with 16 buttons in the form of a 4x4 matrix. Equipped with an 8-pin connector with 2.54 mm pitch

The touch sensor module (touch button) can be used as a replacement for traditional mechanical buttons. It operates based on the TTP223-B system, which measures the capacity of the metal field on the module. The module has a connector in accordance with the Grove standard. Seeed studio 101020037

8-position DIP-Switch Module

Module with a button, LED diode and a yellow cap. DFRobot DFR0029-Y

Module with a button and red LED backlight. The board is equipped with a Gravity connector and communicates via a digital interface. DFRobot DFR0785-R

Module with a button and RGB LED backlight. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 111020049

KAmodPCF8883T is a module with capacitive touch sensor PCF8883 from NXP. The module has a probe placed on the PCB and a diode indicating the state of the chip. It enables work in one of three modes.

Module with a button and yellow LED backlight. The board is equipped with a Gravity connector and communicates via a digital interface. DFRobot DFR0785-Y

Module with 5 colored buttons. Each button is powered independently and has an output informing about its status

Module with a button and blue LED backlight. The board is equipped with a Gravity connector and communicates via a digital interface. DFRobot DFR0785-B