zł17.07 tax excl.
Module with a bistable button and green LED backlight. The board is equipped with a Gravity connector and communicates via a digital interface. DFRobot DFR0785-G
Module with a self-locking button and green LED backlight. The board is equipped with a Gravity connector and has a digital output. The LED backlight turns on when the button is pressed. The module is supplied with the voltage of 3.3 V or 5 V. Full documentation of the module with examples of use is available on the product Wiki page.
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Bluno - BLE with Arduino Uno
Switch module with an interlock. DFRobot DFR0423
Educational micro:bit module with 32-bit ARM Cortex-M4 microcontroller. Manufactured to interest the youngest in computer engineering. SparkFun DEV-17287
Soil moisture sensor with analog output. The probe has two pointed tabs, making it easy to insert into the ground. It is supplied with the voltage of 3.3V or 5V. DFRobot SEN0114
Sensor that detects the concentration of chlorine. Equipped with a factory calibrated probe. It communicates via the I2C interface, UART or analog output. DFRobot SEN0468
No product available!
LM35 analog temperature sensor module for Arduino. DFRobot DFR0023
Module with an analog MQ2 gas sensor. It enables the detection of LPG, butane, propane, methane, alcohol, hydrogen and smoke. It is powered with the voltage of 5 V and has an analog output. DFRobot SEN0127
Module with digital barometer BMP388. The system measures pressure in the range from 300 to 1250 hPa and temperature from -40 ℃ to 80 ℃. DFRobot SEN0251
Gravity sensor adapter with 3-pin terminal connector. There are two 10 kΩ pull-up and pull down resistors on the board, set with a jumper. DFRobot DFR0055
The MPX5700AP air pressure sensor with a measuring range from 15 to 700 kPa. It communicates via the I2C interface. DFRobot SEN0456
Contrast sensor module. It has two integrated operating modes: analog and digital. It has the ability to set the digital mode for color detection. DFRobot SEN0147
Expansion board for Arduino, allows easy connection of XBee modules, has separate outputs for I2C, SPI and UART buses. The built-in 3.3V voltage stabilizer and operating mode switch make it easier to program the Arduino when the XBee module is connected to the sockets. DFRobot DFR0265
Gravity: Formaldehyde (HCHO) Sensor is a module for measuring the concentration of formaldehyde (methane) in the air. It can be supplied with voltage in the range of 3.3 ... 6V. DFRobot SEN0231
Laser dust sensor is a digital universal particle concentration sensor,it can be used to obtain the number of suspended particulate matter in a unit volume of air within 0.3 to 10 microns, namely the concentration of particulate matter, and output with digital interface, also can output quality data of per particle. DFRobot SEN0177
Gravity: Voice Recorder Module is a sound recording module powered by 5V voltage. It can store sounds up to 10 seconds long. DFRobot SEN0197
Module with an analog MQ6 propane sensor. It is powered with the voltage of 5 V and has an analog output. DFRobot SEN0131
A sensor that detects the concentration of nitrogen dioxide. Equipped with a factory calibrated probe. It communicates via the I2C interface, UART or analog output. DFRobot SEN0471
No product available!
DFRobot 315MHz RF receiver module using SC2272-L4 low power decoder chip. DFRobot TEL0112
A module with a 16-channel input/output port expander controlled by an I2C interface. It was based on the MCP23017 chip and equipped with a Gravity connector. DFRobot DFR0626
Module with a bistable button and green LED backlight. The board is equipped with a Gravity connector and communicates via a digital interface. DFRobot DFR0785-G