Gravity: LED Switch - module with self-locking button and LED backlight (yellow)

Nano I / O Shield for Arduino Nano is an expansion board for Arduino Nano that provides digital, analog pins, power inputs and a connector for the Bluetooth module. DFRobot DFR0012

BME280 integrates onboard temperature sensor, humidity sensor and barometer. It provides both SPI and I2C interfaces; and can be widely used in environmental monitoring, story height measurement and Internet of Things (IoT) control and so on. SEN0236

DFRobot 315MHz RF receiver module using SC2272-L4 low power decoder chip. DFRobot TEL0112

DFR0464

Gravity: I2C VEML7700 Ambient Light. Sensor SKU. SEN0228

Gravity Colorful LED is an LED twinkles with seven colors--the colors of rainbow. DFRobot DFR0474

Clock & Timer Development Tools Gravity I2C SD2405 RTC. DFR0469

Gravity: Analog Signal Isolator is a module that allows to isolate sensors in the system and eliminate mutual interference of sensors powered by 5V. DFRobot DFR0504

Module 4-pin sensor adapter. DFRobot FIT0511

Measurement module for dissolved oxygen in water. It allows you to determine the level of water quality. The set includes a measuring module and a probe. DFRobot SEN0237-A

Expansion board for micro:bit modules with connectors compatible with Boson and Gravity sets. DFRobot DFR0521

Audio Analyzer is a module with sound analyzer based on the MSGEQ7 system. It divides the sound into seven frequency bands, and then allows you to read the peak levels of each band. It allows you to measure the sound in the following frequencies: 63Hz, 160Hz, 400Hz, 1kHz, 2.5kHz, 6.25kHz and 16kHz. DFRobot DFR0126

The expansion board is designed for DFRduino M0 or Bluno M0 sets. The board has 31 GPIO pins (including 6 PWM and 6 ADC inputs), UART, I2C and SPI interfaces. The pins are color coded according to the Gravity standard. DFRobot DFR0412

A module with an EMG sensor that detects the activity of human muscles and neurons. Generates an analog signal in the range from 0 to 3 V on the output, it does not require the use of a conductive gel. DFRobot SEN0240

Gravity: Analog TDS Sensor / Meter is an analog water purity measurement module. It is powered by 3.3 ... 5.5V voltage and has an analogue output interface. Module compatible with Arduino. DFRobot SEN0244

Module with an analog sound intensity sensor. It enables measurement in the range from 30 dB to 130 dB with a measurement error of ± 1.5 dB. The module returns the output voltage in the range of 0.6 to 2.6 V. DFRobot SEN0232