Dedicated cooling fan for NVIDIA Jetson Nano mini computers. Powered by 5V, controlled by PWM signal. Waveshare Fan-4020-PWM-5V
List of products by brand Waveshare
There are 911 products.
USB-RS485 converter for industrial applications. It provides communication between the USB interface and the RS485 serial standard. Waveshare USB TO RS485 (B)
CAN module based on the SN65HVD230 system, allows you to connect a microcontroller with a CAN bus interface
Heatsink designed for mounting on Raspberry Pi CM4 modules. Komaptybilny with base boards Compute Module 4 IO Board and Compute Module 4 PoE Board. Waveshare CM4-HEATSINK
2.23" OLED display overlay designed for Raspberry Pi minicomputers. Module based on SSD1305 driver, communicates via SPI or I2C interface. Waveshare 2.23inch OLED HAT
USB - UART converter based on the PL2303 chip
The board with the RP2040 microcontroller equipped with two ARM Cortex-M0+ cores, which work at a frequency of 133 MHz, 264 kB RAM. The board also has 2 MB of QSPI flash memory. The system can be programmed in C/C++ or MicroPython. Waveshare RP2040-Zero
RTC DS1302 real time clock module with CR2032 battery and solder pins. Waveshare DS1302 RTC Board
The 15 cm long tape allows you to connect the camera to the Raspberry Pi Zero. Waveshare RPi Zero V1.3 Camera Cable 15cm
UART - USB converter based on the FT232RL chip with TX, RX, RTS and CTS lines led out to the pin connector, the remaining lines available on solder fields for pin connectors. Micro-USB socket. Voltage supply from 3.3 to 5 V. FT232 USB UART Board (micro)
RS485 communication board, SP3485 on board, 3.3V
30 cm long tape, a knockout attempt for Raspberry Pi Zero. Waveshare RPi Zero V1.3 Camera Cable 30cm
USB TO UART solution with USB Type A connector, Waveshare
Board with the RP2040 microcontroller in the form of a USB dongle. Equipped with edge connectors, RGB LED, boot and reset button. Waveshare RP2040-One
RS485 CAN HAT is an extension designed for the Raspberry Pi mini-computer in the form of a HAT overlay. Adds RS485 and CAN interfaces for the Raspberry Pi plate. Interface signals are derived as screw and goldpin connectors. RS485 CAN HAT
PoE power supply module designed for Raspberry Pi 3B + and 4B. It allows you to use the PoE interface to power the Raspberry Pi via an Ethernet cable, eliminating the need for a separate power supply. Waveshare PoE HAT (B)
3-port HUB module with USB 2.0 interface and RJ45 connector. Designed for Raspberry Pi Zero. Housing included. Waveshare ETH-USB-HUB-BOX
10.1inch Resistive Touch Screen LCD, HDMI interface, Designed for Raspberry Pi
USB TO UART solution with USB Type A connector