Matrix keyboard module 1x4

Module with a button and red LED backlight. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 111020044

Touch keyboard module with 8 buttons based on the TTP226 chip. It is equipped with a connector with derived signals and LEDs that indicate the state of each button

Two-axis joystick with "ENTER" button, analogue output signal

Module with a button and blue LED backlight. The board is equipped with a Gravity connector and communicates via a digital interface. DFRobot DFR0785-B

8-position DIP-Switch Module

Module with a bistable button and white LED backlight. The board is equipped with a Gravity connector and communicates via a digital interface. DFRobot DFR0785-W

Universal module for building a keyboard. The set consists of a control board with a miniUSB socket and cables with crocodile clips

Keyboard module with 10 tact switch buttons. The state of the buttons can be read using digital pins or a common analog output. DFRobot DFR0792

Touch keyboard module with 8 buttons and one line sensor (slider)

Module with a button and yellow LED backlight. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 111020045

Touch keyboard module with 4 buttons based on the TTP224 system. It is equipped with a connector with derived signals and 4 LEDs signaling the state of each button

Switch module with an interlock. DFRobot DFR0423

KAmodPCF8883T is a module with capacitive touch sensor PCF8883 from NXP. The module has a probe placed on the PCB and a diode indicating the state of the chip. It enables work in one of three modes.

Module with backlight in the form of RGB NeoPixel diode dedicated to CHOC buttons (or compatible). Adafruit 5756

Module with a button and yellow LED backlight. The board is equipped with a Gravity connector and communicates via a digital interface. DFRobot DFR0785-Y

SEN-14520