Gravity: Digital Push Button - button with LED (green)

Module with backlight in the form of RGB NeoPixel diode dedicated to CHOC buttons (or compatible). Adafruit 5756

Module for 4 mechanical buttons with LED backlight in the form of NeoPixel diodes. Communicates via I2C. Adafruit 4980

Keyboard module with five colored buttons. The board is equipped with a Gravity connector and has an analog output. Powered with the voltage of 3.3 V or 5 V. DFRobot DFR0075

Keyboard module with 10 tact switch buttons. The state of the buttons can be read using digital pins or a common analog output. DFRobot DFR0792

Module with a bistable button and blue LED backlight. The board is equipped with a Gravity connector and communicates via a digital interface. DFRobot DFR0785-B

Module with a button and re LED backlight. Controlled by the I2C interface, it has a built-in debouncing mechanism, pull-up resistors as well as interrupts and a FIFO queue. SparkFun BOB-15932

Module with a button and red LED backlight. The board is equipped with a Gravity connector and communicates via a digital interface. DFRobot DFR0785-R

Two-axis joystick with "ENTER" button, analogue output signal

Touch keyboard module with 4 buttons based on the TTP224 system. It is equipped with a connector with derived signals and 4 LEDs signaling the state of each button

CAP1188 - 8-Key Capacitive Touch Sensor Breakout - I2C or SPI - Adafruit 1602

Module with 12-position rotary switch. It is supplied with the voltage ranging from 3.3 V to 12 V and has an analog output (Gravity connector). DFRobot SEN0156

Module with a button, LED diode and a red cap. DFRobot DFR0029-R

Module with AT42QT1060 controller - contectless keyboard controller, Kamami, RoHS.

Touch keyboard module with 8 buttons and one line sensor (slider)

Module with a button, LED diode and a blue cap. DFRobot DFR0029-B

Universal module for building a keyboard. The set consists of a control board with a miniUSB socket and cables with crocodile clips