Gravity: Digital Push Button - button with LED (white)

4x4 (16) Key Matrix Membrane Switch Keyboard, RoHS

CAP1188 - 8-Key Capacitive Touch Sensor Breakout - I2C or SPI - Adafruit 1602

Gravity: Joystick Module V2 is a joystick module with two analog outputs (X and Y axis) and a digital output (Z axis) supplied with 3.3 ... 5V voltage. DFRobot DFR0061

Module with 5 colored buttons. Each button is powered independently and has an output informing about its status

Touch Sensor Switch Module for Arduino, RoHS

Module with a button and green LED backlight. Controlled by the I2C interface, it has a built-in debouncing mechanism, pull-up resistors as well as interrupts and a FIFO queue. SparkFun BOB-16842

Touch keyboard module with 8 buttons and one line sensor (slider)

Two-axis joystick with "ENTER" button, analogue output signal

8-position DIP-Switch Module

Keyboard module with 12 buttons (3x4) and analog output

Module with AT42QT1060 controller - contectless keyboard controller, Kamami, RoHS.

Touch keyboard module with 4 buttons based on the TTP224 system. It is equipped with a connector with derived signals and 4 LEDs signaling the state of each button

Module with a button and blue LED backlight. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 111020046

Membrane keypad module with 12 (3x4) buttons. It is equipped with a tape terminated with a 7-pin connector

Module with a button and re LED backlight. Controlled by the I2C interface, it has a built-in debouncing mechanism, pull-up resistors as well as interrupts and a FIFO queue. SparkFun BOB-15932

The module is equipped with two buttons in red and blue. It communicates via a digital interface and allows you to add simple controls to your M5Stack based project. M5Stack U025