Stepper motor controller with DRV8825 system
search
  • Stepper motor controller with DRV8825 system
  • Stepper motor controller with DRV8825 - bottom view
ID: 561436
5906623455287
zł7.98
Tax included

zł6.49 tax excl.

DRV8825 Stepper Motor Driver Carrier is a DRV8825 stepper motor driver that allows you to supply a bipolar current of up to 1.5 A per phase, without using a heat sink. The system can be supplied with voltage up to 45V, in the set there is a heat sink. It is compatible with Polol 2133

24h
Available
Available quantity: 51
 

Free shipping

free shipping in Poland for all orders over 500 PLN

 

Same day shipping

If your payment will be credited to our account by 11:00

 

14 days for return

Each consumer can return the purchased goods within 14 days

Description

The stepper motor driver with the DRV8825 system allows the bipolar motor to be supplied with up to 1.5 A current per phase, without the use of a heat sink. The system can be supplied with voltage up to 45V, the set contains a heat sink (maximum current efficiency of the DRV8825 system increases to 2.2A with cooling installed). It is compatible with Polol 2133 .

properties

  • Driver module with DRV8825 system
  • Possibility to control: full step, half step, 1/4 step, 1/8 step, 1/16 step, 1/32 step
  • Adjustable motor current using a potentiometer,
  • Intelligent control, automatically selects the correct slope rise mode (fast rise or slow rise)
  • Supply voltage: 8.2V-45 V
  • Built-in voltage regulator
  • Compatible with systems with 3.3V and 5V operating voltages
  • Protection: thermal and overcurrent
  • Protection against too low input voltage
  • Protection against short-circuit to ground and short-circuit of the load
  • Four-layer laminate to improve heat dissipation
  • Exposed thermal pad on the bottom of the plate (enables the installation of the heat sink)

Included

  • Driver module with DRV8825 system
  • Radiator with dimensions of 9mm x 9.2mm
561436

You might also like

Other products in the same category (16)