Kitronik 2718 - sewable coin cell battery holder

This is the second version of the Flora NeoPixels, which runs at at \'high speed\' 800KHz communication. Adafruit 1260

DEV-23903

Adafruit 1059 - Flora Wearable Ultimate GPS Module

This e-textile module allows you to program interactive projects such as clothing, accessories, and educational gadgets. It features a PICAXE 14M2 chip, a white LED, a momentary pushbutton, and 6 I/O pins with PWM and ADC functionality, allowing you to control LEDs, buzzers, and other components. The module is powered from 3 to 5.5V via a JST connector or wired connections, and its large connection points facilitate installation in fabrics. Kitronik 2751

A miniature module with a programmed AVR Attiny85 microcontroller, equipped with 8 KB of Flash memory, 4 digital pins, analog input and 2 PWM channels. By connecting the LEDs to the digital outputs of the module, interesting lighting effects can be obtained. SparkFun DEV-10899

Button cell battery socket specially designed for e-textiles from Kitronik. It has large connection points that allow easy connection of the conductive thread. Dedicated to CR2032 batteries. Kitronik 2701

XBee adapter with pads with holes for sewing the module to clothes and fabrics. SparkFun DEV-12921

The Flora budget starter kit contains everything you need to start an adventure with smart clothing. Included, among others motherboard, LED diodes, conductive cord, battery basket. Adafruit 1405

This module allows you to automatically turn on LEDs in the dark thanks to a built-in light sensor. It comes with a CR2032 battery holder and a slide switch to turn the module on and off. It also has two sets of pads for connecting LEDs, allowing for flexible lighting design. Kitronik 2721

GEMMA M0 is an intelligent clothing controller from Adafruit. In relation to the classic GEMMA board, it was equipped with a 32-bit ATSAMD21E18 microcontroller (based on Cortex M0 +). It has GPIO pins, RGB DotStar diode. The board can be powered by a 3.7 V Li-Ion battery (JST connector). Adafruit 3501

A compact light sensor for e-textile projects that allows devices to be activated based on ambient light levels. The OUT output generates a voltage ranging from 0.9V in low light to 2.9V in bright environments, allowing for the creation of interactive effects in clothing and accessories. Large connection points allow for easy sewing of conductive thread, and the small size makes the module easy to integrate into a variety of projects. Kitronik 2754

A set of 20 modules with RGB diodes with a diameter of 12.5 mm. The diodes have a 24-bit range of colors. Adafruit 1559

A miniature module with a LiPo battery charger with a capacity of 500 mA. SparkFun DEV-11893

FLORA is Adafruit\'s fully-featured wearable electronics platform. It\'s a round, sewable, Arduino-compatible microcontroller designed to empower amazing wearables projects. Adafruit 659

Sewable with a 3-pin JST wiring adapter with 3 holes on the board perfect for conductive thread or soldering, wired to a single 3-pin JST-PH Adapter. Sdafruit 2566

Kit with LEDs, battery, needles and conductive thread that allows you to sew LED lighting into clothes. SparkFun DEV-11590