MP3 player with microSD slot and USB

WAV files player module. It is based on a DAC converter and an audio amplifier, there is a 3.5 mm audio output on the board. The files are played from the microSD card. Adafruit 94

Mini MP3 player with 128 MB built-in memory. It can work as a separate device and play sounds or be controlled via the UART serial interface. DFRobot DFR0768

WIG-13720

Sound terminal expansion board based on STA350BW for STM32 Nucleo

Crowtail-MP3 Player 2.0 is a universal audio module with MP3/WAV/WMA playback, microSD card support and a UART interface. Intended for projects requiring the playback of voice messages, sound effects or music.

Adafruit 2217

Stereo audio amplifier with Bluetooth communication. It can be powered with the voltage from 8 to 26 V and has two outputs with a power of 50 W. The set includes a remote control

Bluetooth audio receiver module that allows wireless transmission of sounds. It is equipped with a PCB antenna and a 3.5 mm Jack audio connector

WM8960 stereo codec module with driver for 1W class D speakers and headphones. It uses the I2S interface and the I2C bus to configure the system. SparkFun BOB-21772

MP3 panel for installation in the audio device. It allows you to play files in MP3 format from a USB memory or a microSD card. It has a built-in 3.5mm Jack connector with an audio output

Audio module with DAC, headphone amplifier and display, designed to work with the Raspberry Pi. It is based on the PCM5100A system and communicates via the I2S interface. Pimoroni PIM482

Adafruit 2342

MP3 panel with LCD display for installation in the audio device. It allows you to play files in MP3, WAV and WMA format from USB memory, microSD card, via AUX and Bluetooth 5.0. It has a built-in FM receiver

Mini MP3 player with microSD card support. It can work as a separate device and play sounds from the card or be controlled via the UART serial interface.

MP3 panel with a HiFi amplifier for installation in an audio device. It allows you to play files from USB memory, SD card, via AUX and Bluetooth. It has a built-in FM receiver

This breakout board, the ultimate companion for the VLSI VS1053B DSP codec chip, can decode a wide variety of audio formats MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC, WAV (PCM and ADPCM); it can be used to record audio in both PCM (WAV) and compressed Ogg Vorbis. 8 GPIO pins can be used for lighting up small LEDs or reading buttons. Adafruit 1381