Category: MP3/WAV playback modules

Audio receiver with Bluetooth 4.2 module. It is powered by a microUSB connector and is equipped with 5 control buttons

WIG-13720

WM8960 stereo codec module with driver for 1W class D speakers and headphones. It uses the I2S interface and the I2C bus to configure the system. SparkFun BOB-21772

This breakout board, the ultimate companion for the VLSI VS1053B DSP codec chip, can decode a wide variety of audio formats MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC, WAV (PCM and ADPCM); it can be used to record audio in both PCM (WAV) and compressed Ogg Vorbis. 8 GPIO pins can be used for lighting up small LEDs or reading buttons. Adafruit 1381

Bluetooth audio receiver module that allows wireless transmission of sounds. It is equipped with a PCB antenna and edge connectors

Mini MP3 player with 128 MB built-in memory. It can work as a separate device and play sounds or be controlled via the UART serial interface. DFRobot DFR0768

Expansion module with stereo audio output equipped with LM4550 chip with AC\'97 codec. It allows you to play and record high-quality stereo sounds. Numato Lab EXPAUD003

WAV files player module. It is based on a DAC converter and an audio amplifier, there is a 3.5 mm audio output on the board. The files are played from the microSD card. Adafruit 94

Audio module with DAC, line output and display, designed to work with the Raspberry Pi. Pimoroni PIM483

WIG-12897WAV file player module controlled by UART interface or switching inputs. It is based on a 2 W audio amplifier. The board has a 3.5 mm audio output and a speaker connector. The files are played from the microSD card. SparkFun DEV-13660

Adafruit 2217

Adafruit 2342

Module with VS1000D chip and SPI Flash memory, which allows you to play sounds in Ogg Vorbix and WAV format stored on a SPI Flash memory. SparkFun DEV-14006

Audio player module with Ogg Vorbis, MP3, AAC, WMA and MIDI codec. Equipped with a microSD slot, audio amplifier and LiPo charger. SparkFun DEV-11013

This Bluetooth Audio receiver module includes a USB port and TF card slot. With a pre-amp output, you can drive headphones or a 3W speaker directly. You can also add an active power amplifier and connect a loudspeaker. The module supports MP3, WMA, WAV and lossless FLAC audio formats. DFRobot TEL0108

Audio player module with MP3 decoder and microSD card slot. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 107020069

MP3 player module controlled by I2C interface or switching inputs. It is based on a 1.4 W audio amplifier. The board has a 3.5 mm audio output and a connector for connecting a loudspeaker. Files are played from a microSD card. SparkFun DEV-19030

Qwiic Tsunami Super WAV Trigger - a module with a multi-channel WAV player

Sound terminal expansion board based on STA350BW for STM32 Nucleo

Audio module based on a 32-bit PCM5102A DAC converter intended for cooperation, among others with Raspberry Pi minicomputers. Communication via the I2S interface. GY-PCM5102