LM4550 AC'97 Stereo Audio Codec - audio expansion module with AC'97 LM4550 codec

Audio module that allows you to play sounds from a USB memory, microSD card, via Bluetooth or FM radio. It is equipped with a microphone, 3.5 mm audio jack and control buttons

WAV files player module. It is based on a DAC converter and an audio amplifier, there is a 3.5 mm audio output on the board. The files are played from the microSD card. Adafruit 94

Audio receiver with Bluetooth 5.0 communication based on the QCC3008 module. It is equipped with an insulated converter that enables power supply with 12 V voltage

This breakout board, the ultimate companion for the VLSI VS1053B DSP codec chip, can decode a wide variety of audio formats MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC, WAV (PCM and ADPCM); it can be used to record audio in both PCM (WAV) and compressed Ogg Vorbis. 8 GPIO pins can be used for lighting up small LEDs or reading buttons. Adafruit 1381

This Bluetooth Audio receiver module includes a USB port and TF card slot. With a pre-amp output, you can drive headphones or a 3W speaker directly. You can also add an active power amplifier and connect a loudspeaker. The module supports MP3, WMA, WAV and lossless FLAC audio formats. DFRobot TEL0108

Module with VS1000D chip and SPI Flash memory, which allows you to play sounds in Ogg Vorbix and WAV format stored on a SPI Flash memory. SparkFun DEV-14006

Mini MP3 player with 128 MB built-in memory. It can work as a separate device and play sounds or be controlled via the UART serial interface. DFRobot DFR0768

Bluetooth audio receiver module enclosed in a housing that enables wireless transmission of sounds. It is equipped with a PCB antenna, microphone, 3.5 mm audio jack and control buttons

MP3 panel with a HiFi amplifier for installation in an audio device. It allows you to play files from USB memory, SD card, via AUX and Bluetooth. It has a built-in FM receiver

Bluetooth 4.1 audio receiver with 3.5mm Jack audio output. It allows you to play files via Bluetooth, from a mass memory (flash drive) or from a microSD card. XY-BT

Bluetooth 4.1 audio receiver with 3.5mm Jack audio output. It allows you to play files via Bluetooth, from mass memory (pendrive) or microSD card and supports WAV, APE, MP3 and FLAC formats. XY-BT-L

WIG-13720

WIG-12897WAV file player module controlled by UART interface or switching inputs. It is based on a 2 W audio amplifier. The board has a 3.5 mm audio output and a speaker connector. The files are played from the microSD card. SparkFun DEV-13660

Mini MP3 player with microSD card support. It can work as a separate device and play sounds from the card or be controlled via the UART serial interface. DFRobot DFR0299

Audio module based on a 32-bit PCM5102A DAC converter intended for cooperation, among others with Raspberry Pi minicomputers. Communication via the I2S interface. GY-PCM5102

Audio module with DAC, stereo amplifier and display, designed to work with the Raspberry Pi. Pimoroni PIM484