Pan/Tilt Bracket Kit - micro servo holder kit

Multifunctional lens calibration kit for M12, CS-Mount, C-Mount and DSLR lenses. It allows focus calibration, FoV measurement without the need for additional calculations and focusing. ArduCAM B0226

A set of cameras designed for artificial intelligence projects (two 720p and one 12 MPx) configured via USB. ArduCAM OAK-D

Adapter designed for cameras with a parallel interface. It allows you to connect the camera with the USB Camera Shield module and connect it to a computer via a USB port. ArduCAM B0345

Arducam USB shield is a module that allows you to connect some ArduCam cameras to a PC or minicomputers, eg Raspberry Pi, BeagleBone etc. The module supports most cameras with a serial interface that have a resolution of 0.3 ... 14 MPix. Attached to the module are appropriate libraries that facilitate image processing, eg using OpenCV software. ArduCam B0095

The Arducam CS to M12 adapter allows you to use M12 or CS lenses with the Raspberry Pi HQ camera module, providing a wide range of optical options. ArduCam UB0225

A module that allows you to connect four cameras to a Raspberry Pi. It supports cameras with MIPI interface with a resolution of 5 Mpx, 8 Mpx and 12 Mpx. Arducam B012001

30 cm long tape, a knockout attempt for Raspberry Pi Zero series. Waveshare RPi Zero 2 W Camera Cable 30cm

The Arducam Mini Multi-Camera Adapter Board is an expander that can connect up to 4 ArduCam cameras. ArduCam B0074

300mm ArduCam extension cable. Compatible e.g. with IMX219 image sensor. ArduCam B0186

Base plate designed for Luxonis BW1099 DepthAI SoM modules. It has three interfaces for connecting cameras with a 26-pin connector. ArduCAM B0327

The 15 cm long tape allows you to connect the camera to the Raspberry Pi Zero series. Waveshare RPi Zero V1.3 Camera Cable 15cm

ArduCam CSI to HDMI modules are designed to work with cameras: Raspberry Pi V1 and Raspberry Camera V2. ArduCAM CSI to HDMI allows you to extend the signal from cameras using the HDMI <-> HDMI cable (up to 10 meters). Arducam B0091

The control platform equipped with servos allows you to control the position of the camera in two dimensions. It has a built-in driver and light sensor. Waveshare Pan-Tilt HAT

The adapter allows to extend the CSI / DSI interface using two FFC tapes (by connecting them in one tape). It allows you to connect the camera to a Raspberry Pi computer or a DSI display, for distances using two FFC tapes. Adafruit 3671

DFRobot (FIT0004)

KAmodCSIextender modules are designed to work with Raspberry Pi cameras. KAmodCSIextender allows you to extend the signal from cameras using the HDMI <-> HDMI cable (up to 10 meters).