zł1,324.44 tax excl.
GPS module with u-blox ZED-F9R system. It uses Automotive Dead Reckoning (ADR) technology. It provides highly accurate and continuous positioning by combining the 3D IMU sensor, vehicle dynamics model, correction data and GNSS measurements. SparkFun GPS-22660
GPS module with u-blox ZED-F9R. The module uses Automotive Dead Reckoning (ADR) technology. Provides highly accurate and continuous positioning by combining the 3D IMU sensor, vehicle dynamics model, correction data and GNSS measurements. The ZED-F9R module can receive signals from the GPS, GLONASS, Galileo and BeiDou constellations with an accuracy of 0.2 meters (supports simultaneous reception of four GNSS systems). The module provides position accuracy in cities or in covered areas. Continuous positioning is ensured even under weak signal conditions and is available in the event of total signal loss (e.g. short tunnels and garages). The ZED-F9R is an excellent solution for autonomous robots that require accurate positioning in difficult conditions.
Attention!
For proper operation, the module requires a GPS antenna, which is not included in the set. It must be purchased separately.
The board also has two Qwiic connectors and a USB Type-C connector for communication with the system.
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Multiband GNSS antenna operating in GPS L1 and L2 bands. Can be fixed with a magnet tool or an M4 screw. it is created in a 5 m l cable designed by SMA. u-blox ANN-MB-00
GNSS antenna SPK6618H enabling tri-band reception (L1/L2/L5) for GPS, GLONASS, Galileo and BeiDou constellations. It uses a 5/8 inch 11TPI thread found in high-end antennas and surveying equipment. SparkFun GPS-21801
No product available!
The module is equipped with the LTE-M/NB-IoT u-blox SARA-R510M8S system. It allows you to monitor devices remotely. SparkFun GPS-18031
No product available!
Module with SIM868 designed for GSM, GPRS communication and GNSS positioning. It can communicate within the Bluetooth 3.0 standard. Waveshare Pico-SIM868-GSM/GPRS/GNSS
Module with a GPS receiver based on the MTK3333 chip. It is equipped with a STEMMA QT connector and communicates via the UART or I2C interface. Adafruit 4415
Kit with GNSS RTK Express receiver, L1/L2 antenna and accessories. It allows you to get centimeter-level global positioning measurements using GNSS RTK. SparkFun GPS-18380
No product available!
Kit with GNSS RTK Express Plus receiver, L1/L2 antenna and accessories. It allows you to get centimeter-level global positioning measurements using GNSS RTK. SparkFun GPS-18589
No product available!
Kit with GNSS RTK Surveyor receiver, L1/L2 antenna and accessories. It allows you to get centimeter-level global positioning measurements using GNSS RTK. SparkFun GPS-17370
No product available!
The GPS receiver is equipped with a GP-735T module. It is supplied with the voltage from 3.3 to 5.5 V and communicates via the UART interface. SparkFun GPS-13670
Extension board designed for MicroMod main modules. Equipped with the ZED-F9P GNSS receiver. It can receive data from GPS, GLONASS, Galileo and BeiDou systems. SparkFun DEV-17722
No product available!
Board with the Artemis chip, the GNSS ZOE-M8Q module and the Iridium 9603N satellite receiver. It allows you to send and receive short messages with data anywhere in the world. SparkFun WRL-18712
No product available!
Module with SIM868 designed for GSM, GPRS communication and GNSS positioning. It can communicate within the Bluetooth 3.0 standard. SB Components 21895
Industrial 4G module with Qualcomm SIM7600E-H chip. It allows you to connect devices with USB or UART communication with 4G networks. Waveshare SIM7600E-H 4G DONGLE
No product available!
GPS module with GNSS receiver ZED-F9T. It supports L1 / L2 / E5b bands and provides clocking accuracy of up to five nanoseconds. Qwiic connector. SparkFun GPS-18774
No product available!
Module with GPS PA1616D receiver based on the MTK3333 system. It is equipped with a USB type C connector and a USB-UART converter. Adafruit 4279
Module with GNSS PA1616D receiver based on the MTK3333 chip. Supports GPS and GLONASS positioning systems. Adafruit 5440
The set with the RM500Q-GL module is designed to work with the Raspberry Pi minicomputer. It supports 5G, 4G and 3G networks and supports GNSS positioning. Waveshare RM500Q-GL 5G HAT (with case) (EU)
No product available!
The set with the RM500Q-GL module is designed to work with the Raspberry Pi minicomputer. It supports 5G, 4G and 3G networks and supports GNSS positioning. Waveshare RM500Q-GL 5G HAT (EU)
No product available!
GPS module with u-blox ZED-F9R system. It uses Automotive Dead Reckoning (ADR) technology. It provides highly accurate and continuous positioning by combining the 3D IMU sensor, vehicle dynamics model, correction data and GNSS measurements. SparkFun GPS-22660