zł310.45 tax excl.
GPS module with 72-channel GNSS NEO-M8U receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It has UART, I2C and SPI interfaces. Built-in accelerometer and gyroscope. SparkFun GPS-16329
GPS module with 72-channel GNSS NEO-M8U receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. Determining the position with the help of the module allows you to achieve an accuracy of up to 2.5 m. The module uses Untethered Dead Reckoning (UDR) technology, which provides a very accurate and continuous position by using the IMU sensor and GNSS measurements without having to connect the system to the vehicle. Provides position accuracy in cities or in covered areas. Continuous positioning is ensured even under low signal conditions and is available in the event of total signal loss (e.g. short tunnels and garages).
The module has a Qwiic connector with an I2C interface. Additionally, for users who do not work with the Qwiic system, UART, I2C and SPI interfaces were provided on pins with a 2.54 mm raster. There is also a socket on the board with a battery supporting the voltage, which significantly accelerates the start of the device after a momentary power failure.
The module is configured via a USB connector and a dedicated u-center application. The module is also available with the Arduino library with numerous examples of use.
Attention!
For the proper operation of the module, an external antenna with a U.FL connector is required, which is not included in the set.Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Antenna with built-in LNA amplifier with high sensitivity, for mounting in a device using a GPS module. The antenna has a 75mm cable, terminated with a U.FL plug (IPEX). Dimensions of the device: 25 x 25 x 4 mm
 No product available!
 No product available!
GPS module with NEO-M9N 92-channel GNSS receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It has UART, I2C and SPI interfaces. SparkFun GPS-15712
GPS module with NEO-M9N 92-channel GNSS receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It has UART, I2C and SPI interfaces. SparkFun GPS-15733
Flexible 4-core cable, 100 mm long, terminated on both sides with a Qwiic plug. Sparkfun PRT-17259
Flexible 4-core cable, 200 mm long, terminated on both sides with a Qwiic plug. Sparkfun PRT-17258
Antenna with built-in LNA amplifier with high sensitivity, for mounting in a device using a GPS module. The antenna has a 110mm cable, terminated with a U.FL plug (IPEX). Dimensions of the device: 8 x 8 x 7mm
 No product available!
 No product available!
GPS module with SAM-M10Q GNSS receiver. The chip can receive data from all major positioning systems: GPS, GLONASS, Galileo, QZSS and BeiDou. It has derived UART and I2C interfaces. SparkFun GPS-21834
Module with BDS/GNSS AT6558 receiver. It can receive data from six location systems simultaneously: GPS, GLONASS, Galileo, QZSS, SBAS and BeiDou. It communicates via the UART interface. DFRobot TEL0132
GPS module with GNSS receiver ZED-F9T. It supports L1 / L2 / E5b bands and provides clocking accuracy of up to five nanoseconds. Qwiic connector. SparkFun GPS-18774
 No product available!
 No product available!
GPS module with 72-channel GNSS NEO-M8P-2 receiver. It can receive data from GPS, GLONASS and BeiDou systems. It has USB, UART, I2C and SPI interfaces. RTK and high accuracy up to 25mm. SparkFun GPS-15005
 No product available!
The set with the RM500Q-GL module is designed to work with the Raspberry Pi minicomputer. It supports 5G, 4G and 3G networks and supports GNSS positioning. Waveshare RM500Q-GL 5G HAT (with case) (EU)
 No product available!
GPS module with GNSS receiver ZED-F9P. It can receive data from GPS, GLONASS, Galileo and BeiDou systems. It has USB, UART, I2C and SPI interfaces. RTK and high accuracy up to 10 mm. SparkFun GPS-15136
 No product available!
GNSS module with u-blox ZED-F9R system. It uses Automotive Dead Reckoning (ADR) technology. It provides highly accurate and continuous positioning by combining the 3D IMU sensor, vehicle dynamics model, correction data and GNSS measurements. SparkFun GPS-21305
 No product available!
GNSS module with u-blox ZED-F9R system. It uses Automotive Dead Reckoning (ADR) technology. It provides highly accurate and continuous positioning by combining the 3D IMU sensor, vehicle dynamics model, correction data and GNSS measurements. SparkFun GPS-22693
 No product available!
Small GPS location module with L80-39 GPS chip, USB and TTL two ports,easy to be used with Raspberry Pi, Arduino, STM32 and other kind of micrcontrollers. The GPS module uses NMEA0183 communication protocol, integrated ultra-small SMA antenna connector. DFRobot TEL0119
 No product available!
The set with the RM500Q-GL module is designed to work with the Raspberry Pi minicomputer. It supports 5G, 4G and 3G networks and supports GNSS positioning. Waveshare RM500Q-GL 5G HAT (EU)
 No product available!
 No product available!
Module with GNSS PA1616D receiver based on the MTK3333 chip. Supports GPS and GLONASS positioning systems. Adafruit 5440
 No product available!
                    GPS module with 72-channel GNSS NEO-M8U receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It has UART, I2C and SPI interfaces. Built-in accelerometer and gyroscope. SparkFun GPS-16329