

The GPS receiver is equipped with a 56-channel GP-735T module based on the 7th generation uBlox chipset. It can work with a tracking sensitivity of -162dBm and only 29 seconds of cold start time. It has a built-in antenna and communicates via the UART interface. By default it works with a refresh rate of 1 Hz, which can be increased to 10 Hz. The module is supplied with the voltage from 3.3 V to 5.5 V through a 6-pin JST SH connector. Thanks to its small size, it can be used in small devices and mobile robots.
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Shield with a 6-pin JST SH connector dedicated to Arduino Mini. It allows you to connect the GPS module with the GP-735 chip. SparkFun GPS-14030
Adapter with 6-pin JST SH connector for holes with 2.54 mm pitch. Dedicated to GPS modules. SparkFun BOB-11818
Female-female cable, 63 cm long, with JST-SH 6-pin plug on both sides. Suitable for micro DC motor encoders with gear. Pololu 4769
Female-female cable, 40 cm long, with JST-SH 6-pin plug on both sides. Suitable for micro DC motor encoders with gear. Pololu 4768
Female-female cable, 25 cm long, with JST-SH 6-pin plug on both sides. Suitable for micro DC motor encoders with gear. Pololu 4767
GPS module with u-blox ZED-F9R system. It uses Automotive Dead Reckoning (ADR) technology. It provides highly accurate and continuous positioning by combining the 3D IMU sensor, vehicle dynamics model, correction data and GNSS measurements. SparkFun GPS-22660
No product available!
The set with the RM500Q-GL module is designed to work with the Raspberry Pi minicomputer. It supports 5G, 4G and 3G networks and supports GNSS positioning. Waveshare RM500Q-GL 5G HAT (with case) (EU)
No product available!
GPS module with 72-channel GNSS ZOE-M8Q receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It has UART and I2C interfaces. SparkFun GPS-15193
NB-IoSIM7000C Arduino NB-IoT / LTE / GPRS / GPS Expansion Shield is an advanced expansion board for Arduino. It has support for SIM cards and NB-IoT cards. Thanks to the GNSS module (Global Navigation Satellite System), it supports GPS, GLONASS, Galileo, QZSS and BeiDou GPS navigation systems. The module is powered by 7 ... 12V voltage. DFRobot DFR0505
No product available!
The module is equipped with the LTE-M/NB-IoT u-blox SARA-R510M8S system. It allows you to monitor devices remotely. SparkFun GPS-18031
No product available!
Advanced IoT module combining global LTE-M/NB-IoT connectivity with precise GNSS positioning (GPS, GLONASS, BeiDou, Galileo). With wide compatibility, two antenna interfaces and AT Command support, it is ideal for projects requiring reliable data transmission and real-time location tracking. M5Stack U137
Adafruit 2324
GPS module with GNSS L76X receiver. It can receive data from GPS, BDS and QZSS systems. It uses the UART interface and offers an accuracy of up to 2.5 m. Waveshare L76X GPS HAT
GNSS receiver module dedicated to Raspberry Pi minicomputers. It provides simultaneous reception of up to three types of satellite systems, including GNSS with GPS, Beidou, Galileo and GLONASS. Waveshare NEO-M8Q GNSS HAT
No product available!
GNSS receiver module dedicated to Raspberry Pi minicomputers. It provides simultaneous reception of up to three types of satellite systems, including GNSS with GPS, Beidou, Galileo and GLONASS. Waveshare NEO-M8T GNSS TIMING HAT
No product available!
GPS module with 72-channel GNSS NEO-M8U receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It has UART, I2C and SPI interfaces. Built-in accelerometer and gyroscope. SparkFun GPS-16329
GPS module with NEO-M9N 92-channel GNSS receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It has UART, I2C and SPI interfaces. SparkFun GPS-15733
No product available!
L76B based GNSS module that can work with GPS, BDS and QZSS systems. Communication via the UART interface. Waveshare Pico-GPS-L76B
GPS module with 72-channel GNSS SAM-M8Q receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It has UART and I2C interfaces. SparkFun GPS-15210
The GPS receiver is equipped with a GP-735T module. It is supplied with the voltage from 3.3 to 5.5 V and communicates via the UART interface. SparkFun GPS-13670