zł243.09 tax excl.
GPS module with SAM-M10Q GNSS receiver. The chip can receive data from all major positioning systems: GPS, GLONASS, Galileo, QZSS and BeiDou. It has derived UART and I2C interfaces. SparkFun GPS-21834
GPS module with GNSS receiver SAM-M10Q. It has a built-in chip antenna and is compatible with the L1 band in all five GNSS constellations (GPS L1 C/A, QZSS L1 C/A L1S, GLONASS L1OF, BeiDou B1C and Galileo E1B/C). The positioning accuracy is 1.5 m, the maximum update rate is 18 Hz when transmitting with one GNSS constellation (5 Hz maximum with four GNSS constellations), and the cold start time to fix is 23 seconds.
The module has a Qwiic connector with an I2C interface. In addition, for users who do not work with the Qwiic system, UART and I2C interfaces are provided on pins with a raster of 2.54 mm. The board also has a socket with a backup battery, which significantly speeds up the start of the device after a temporary power failure.
The M10Q module is the successor to the u-blox M8Q chip and a drop-in replacement with updated features that reduce power consumption by nearly half while improving performance and accuracy. The SAM-M10Q can receive up to four GNSS constellations simultaneously, which improves fix time and positioning accuracy even in areas with limited satellite view.
The configuration of the module is done through a dedicated u-center2 application. The module is also available Arduino library with numerous examples of use and a tutorial.
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Data logger programmed to automatically record data from GPS and Qwiic series sensors. It has a built-in ESP32-WROOM-32E module and IMU sensors ISM330DHCX (accelerometer and gyroscope) and MMC5983MA (magnetometer). SparkFun DEV-20594
Intermediate module of the communication system based on QwiicBus. It allows you to extend the range of the I2C bus. SparkFun COM-18000
End module of the communication system based on QwiicBus. It allows you to extend the range of the I2C bus. SparkFun COM-16988
LIDAR distance sensor with a measuring range from 5 cm to 10 m and a resolution of 1 cm. It communicates via the I2C or ANT interface. The set includes a module with Qwiic SparkFun SEN-18009 connectors
No product available!
Module with DA7280 vibration motor controller and LRA (Linear Resonant Actuator) motor. It allows you to add vibration feedback from the device to the project. SparkFun ROB-17590
No product available!
Ultrasonic ToF (time-of-flight) rangefinder with a range of 4 cm to 1.2 meters. The sensor is able to simultaneously measure the range of several objects in its field of view. Communicates via I2C. SparkFun SPX-17271
No product available!
ToF laser rangefinder. It enables detection of many objects, has a field of view of about 25° and is able to detect objects at a distance of up to 3 m. Communicating via the I2C interface. SparkFun SPX-17072
No product available!
Module with a voltage level converter 3.3 V - 5 V intended for use in the Qwiic system. It has a built-in Step Up converter providing power supply with a voltage of 5 V and a current of up to 100 mA. SparkFun SPX-17238
Flexible Qwiic cable 150 mm long. On one side it is terminated with a female Qwiic connector, and on the other side with single male goldpin connectors. SparkFun PRT-17912
Flexible Qwiic cable, 150 mm long. On one side it is terminated with a female Qwiic connector, and on the other side with single female goldpin connectors. SparkFun PRT-17261
No product available!
Flexible 4-core cable, 50 mm long, terminated on both sides with a Qwiic plug. Sparkfun PRT-17260
Flexible 4-core cable, 100 mm long, terminated on both sides with a Qwiic plug. Sparkfun PRT-17259
Flexible 4-core cable, 200 mm long, terminated on both sides with a Qwiic plug. Sparkfun PRT-17258
Flexible 4-core cable, 500 mm long, terminated on both sides with a Qwiic plug. Sparkfun PRT-17257
Set of sensors with cables. They can detect gestures, movement, touch, sound, and measure humidity, temperature, altitude and acceleration. SparkFun DEV-16156
No product available!
Module with the ATECC608A cryptographic chip. It allows you to add strong security to an IoT node, edge device, or embedded system. SparkFun DEV-18077
Module with 6-axis IMU LSM6DSO sensor, which combines a 3-axis accelerometer and gyroscope, as well as a 9kB FIFO buffer and event handling functions. Communicates via I2C or SPI. SparkFun SEN-18020
GPS module with SAM-M10Q GNSS receiver. The chip can receive data from all major positioning systems: GPS, GLONASS, Galileo, QZSS and BeiDou. It has derived UART and I2C interfaces. SparkFun GPS-21834