

SparkFun Qwiic kit. Contains 10 wires of different lengths and tips. It allows you to connect Qwiic modules to a programming platform or to a prototype board. Each wire has 4 color coded red, black, blue and yellow wires and a 1mm JST-SH connector.
Cable description:
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
No product available!
JST-SH 4-pin SMD connector for modules with Qwiic connectors. Pins\' pitch is 1 mm. Qwiic allows you to connect sensors via the I2C bus. SparkFun PRT-16766
No product available!
Module with integrated proximity and ambient light sensors and IR emitter in the VCNL4040 system. It allows the detection of obstacles in the range of 0 to 20 cm (no dead zone). It communicates via the I2C bus. SparkFun SEN-15177
Sensor module for use in the area of virtual reality (VR). It was based on the BNO080 chip, which integrates the accelerometer, gyroscope and magnetometer with the ARM Cortex M0+ microcontroller. SparkFun SEN-14686
No product available!
Air speed sensor module based on the FS3000-1005 chip. The board is equipped with Qwiic connectors. SparkFun SEN-18377
Module with BME280 environmental sensor. It allows you to measure temperature, humidity and pressure. The sensor is equipped with two communication interfaces: SPI and I2C (Qwiic). SparkFun SEN-15440
Mini module with ToF VL53L5CX sensor with a matrix of 64 pixels and a range of up to 4 m. It is equipped with a Qwiic connector and communicates via the I2C interface. SparkFun SEN-19013
GPS module with 72-channel GNSS SAM-M8Q receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It has UART and I2C interfaces. SparkFun GPS-15210
GPS module with 72-channel GNSS NEO-M8U receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It has UART, I2C and SPI interfaces. Built-in accelerometer and gyroscope. SparkFun GPS-16329
Module with NEO-F9P GNSS receiver. It allows you to track signals from several satellite systems, including GPS, GLONASS, Galileo and Beidou, and offers accuracy of up to 10 mm using an RTK base station. It offers five communication ports: USB type C, UART1, UART2 for RTCM, I2C and SPI reception and Qwiic connectors. SparkFun GPS-23288
No product available!
Module with a digital temperature and humidity sensor based on the SHTC3 system. Communication takes place via the I2C interface. SparkFun SEN-16467
Power monitor module that detects voltages up to 60 VDC and current up to 30 A. It uses the Allegro MicroSystems ACS37800 IC, which simplifies adding monitoring to power systems. SparkFun SPX-17873
No product available!
No product available!
Qwiic to Grove adapter cable, 100 mm long. Enables interoperability between the SparkFun Qwiic Connect system and Seeed Studio I2C-based Grove boards. SparkFun PRT-15109
No product available!
GPS module with SAM-M10Q GNSS receiver. The chip can receive data from all major positioning systems: GPS, GLONASS, Galileo, QZSS and BeiDou. It has derived UART and I2C interfaces. SparkFun GPS-21834
Module with 16-channel PCA9685 servo driver designed for Raspberry Pi minicomputers. The board is equipped with a USB Type C power connector. SparkFun DEV-15316
SparkFun Qwiic kit. Contains 10 wires of different lengths and tips. It allows you to connect Qwiic modules to a programming platform or to a prototype board. SparkFun KIT-15081