Qwiic JST Connector - JST-SH SMD 4-pin connector (vertical)

LPS28DFW absolute pressure sensor module. The chip features a wide measurement range of 260 to 1260 hPa or 260 to 4060 hPa and a high accuracy of 0.5 hPa. It communicates via an I2C interface. SparkFun SEN-21222

Module with EEPROM memory, capacity 512 kbit (64kB). Communication takes place via the I2C interface. The module has 3 jumpers that enable selection of one of 8 addresses. SparkFun SPX-14764

Qwiic adapter designed for micro:bit educational modules. Facilitates access to all pins that are led out on the connector with a pitch of 2.54 mm and the Qwiic connector. SparkFun BOB-16445

Module with a sensor for use in the field of virtual reality (VR). It is based on the BNO086 system, which integrates an accelerometer, gyroscope, magnetometer and a microcontroller with an ARM Cortex M0+ core. SparkFun SEN-22857

Module with 20x4 characters LCD display and ATMega328p microcontroller. The user can communicate with the module through one of the serial interfaces: UART, I2C or SPI. SparkFun LCD-16398

DEV-14477

Module with a differential pressure sensor SDP31 dedicated to measuring the flow rate and air velocity. The arrangement is characterized by wide measuring range from 260 to 1260 hPa and high measurement resolution (0.01 hPa). I2C or SPI communication. SparkFun SPX-14767

GPS module with NEO-M9N 92-channel GNSS receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It has UART, I2C and SPI interfaces. SparkFun GPS-15712

Miniature pressure measurement module equipped with a 25 psi piezoresistive pressure sensor. It allows you to perform calibrated and compensated pressure measurements from 60 mbar to 2.5 bar. SparkFun SEN-16476

Module with digital barometer BMP384. It enables pressure measurement in the range from 300 to 1250 hPa with 24-bit resolution and communicates via I2C. SparkFun SEN-19833

The Qwiic connector overlay provides an easy-to-install way to add Qwiic connectors to Thing Plus and Feather boards. Communication takes place via the I2C interface. Sparkfun DEV-16790

Module with a 4-element 14-segment display. The board is equipped with a Qwiic connector and communicates via the I2C interface. SparkFun COM-16918

Module with the MCP9600 amplifier designed to work with a K-type thermocouple. The module has a PCC connector for connecting this type of thermocouple. I2C communication. SparkFun SEN-16294

Module with 10 addressable RGB LEDs APA102C. Each of the LEDs is independently controlled via the I2C interface, and the line address is modified, so that the modules can be connected with each other. SparkFun COM-18354

Module with DA7280 vibration motor controller and LRA (Linear Resonant Actuator) motor. It allows you to add vibration feedback from the device to the project. SparkFun ROB-17590

End module of the communication system based on QwiicBus. It allows you to extend the range of the I2C bus. SparkFun COM-16988