Qwiic Boost - 3.3/5V voltage level converter module

Module with an analog joystick that returns the X and Y position and the pressed state. The module has an ATtiny85 microcontroller on the board, which processes analog data of the joystick and sends it via the I2C interface. SparkFun COM-15168

Module with transparent OLED display. It has several display areas with different colors. I2C communication. SparkFun LCD-15079

Module with integrated proximity and ambient light sensors and IR emitter in the VCNL4040 system. It allows the detection of obstacles in the range of 0 to 20 cm (no dead zone). It communicates via the I2C bus. SparkFun SEN-15177

Kit with RFID reader (125 kHz) equipped with I2C interface. Works with ID-3LA, ID-12LA and ID-20LA series systems (ID-12LA set). The RFID reader is simply plugged into the module\'s connectors. SparkFun KIT-15209

Module for RFID reader (125 kHz) equipped with I2C interface. Works with ID-3LA, ID-12LA and ID-20LA series systems. The selected RFID reader is simply plugged into the module\'s connectors. SparkFun SEN-15191

Module with three optical inspection sensors (spectrophotometers) from the AS7265x series. The module consists of three sensors; AS72651, AS72652 and AS72653 which can detect wavelengths from 410nm (UV) to 940nm (IR). SparkFun SEN-15050

Module with a button and re LED backlight. Controlled by the I2C interface, it has a built-in debouncing mechanism, pull-up resistors as well as interrupts and a FIFO queue. SparkFun BOB-15932

The Qwiic connector overlay provides an easy-to-install way to add Qwiic connectors to Thing Plus and Feather boards. Communication takes place via the I2C interface. Sparkfun DEV-16790

The Qwiic connector overlay provides an easy-to-install way to add Qwiic connectors to Arduino Nano inserts. Communication takes place via the I2C interface. Sparkfun DEV-16789

Heart rate monitor module based on the popular MAX30101 chip. The board is equipped with connectors compliant with the Qwiic standard. SparkFun SEN-16474

Air quality sensor module based on SGP30 system. The board has been equipped with Qwiic connectors. SparkFun SEN-16531

GPS module with 72-channel GNSS NEO-M8U receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It has UART, I2C and SPI interfaces. Built-in accelerometer and gyroscope. SparkFun GPS-16329

Module with a button and green LED backlight. Controlled by the I2C interface, it has a built-in debouncing mechanism, pull-up resistors as well as interrupts and a FIFO queue. SparkFun BOB-16842

Miniature pressure measurement module equipped with a 25 psi piezoresistive pressure sensor. It allows you to perform calibrated and compensated pressure measurements from 60 mbar to 2.5 bar. SparkFun SEN-16476

Starter kit with Qwiic modules designed to work with the Raspberry Pi. The set consists of an overlay for Raspberry Pi with a standard 40-pin connector and four Qwiic connectors, OLED display, VCNL4040 distance sensor and environmental sensors. SparkFun KIT-16841

Data logger pre-programmed to automatically record data from IMU, GPS and Qwiic series sensors. SparkFun DEV-16832