Bluetooth 5.0 module based on the BT401 chip. Dual communication mode allows for simultaneous transmission of audio sounds and data transmission up to 10 m. The module has a built-in 16-bit audio DAC converter with a headphone amplifier and supports the playback of sounds in MP3, WAV, WMA, FLAC, AAC and APE formats. The user can connect a Flash memory or a microSD card with a capacity of up to 128 GB to the module. Communication with the system takes place via the UART interface and AT commands and is supplied with the voltage from 3.3 V to 5 V. Full documentation is available on the product Wiki page.
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Evaluation Kit with Bluetooth 5.0 BT401. It is equipped with a microSD slot, microUSB connector and two audio outputs. DFRobot DFR0782
Bluetooth module v2.0 + EDR, controlled by AT + commands with built-in antenna.
The BLE Nano from RedBearLab is the smallest Bluetooth 4.1 Low Energy (BLE) development board on the market. With the included MK20 USB in this kit, you’ll be able to deploy firmware to BLE Nano even easier. WRL-14071/WRL-13730
The module with the HC-05 transceiver makes it easy to add Bluetooth communication to an existing project. The system is controlled by exchanging AT commands (UART bus). FC-114
No product available!
Overlay module for Raspberry Pi with GSM, GPRS, GNSS and Bluetooth
AW-CB375NF wireless communication module. It supports 802.11 a/b/g/n/ac Generation 5 Wi-Fi and Bluetooth 5.0 and features an M.2 A/E Key connector. Waveshare Wireless-AW-CB375NF
A compact development board that uses the ESP32-PICO-MINI chip. It provides wireless communication via Bluetooth and serves as an easy-to-configure UART converter. It has a built-in PCB antenna. SparkFun WRL-23287
The ESP32 WiFi and Bluetooth module has a dual-core 32-bit MCU that integrates WiFi HT40 and Bluetooth / BLE 4.2 technology. Designed for mobile devices and Internet of Things (IoT) applications. DFRobot TEL0111
An advanced wireless communication module based on the Bluetooth 5.2 (Bluetooth® Low Energy, BLE) stack, which is designed using the powerful Nordic nRF5340 SoC. It provides GPIO, SPI, UART, TWI, I2C, PDM, PWM, ADC, NFC and USB interfaces for connecting peripherals and sensors. SparkFun WRL-25465
An integrated module combining WiFi, Bluetooth 4.0 and FM radio. It has derived SDIO, UART and PCM interfaces. Ampak AP6335
Comprehensive development platform for Espressif ESP32 a WiFi-compatible microcontroller and nearly 30 I/O pins. DEV-13907
Expander (shield) compatible with Arduino and NUCLEO (STM32) systems, equipped with a Bluetooth 4.1 (BLE) radio module from the SPBTLE-RF family
BLE Beacon transmitting Bluetooth signals at regular intervals. These signals can be detected by Bluetooth-enabled devices such as the SenseCAP T1000 tracker, allowing them to determine their distance from the beacon, creating a location-based indoor positioning solution. Seeed Studio 113991194
No product available!
Powerful, generic Wi-Fi+BT+BLE MCU modules that target a wide variety of applications, ranging from low-power sensor networks to the most demanding tasks, such as voice encoding, music streaming and MP3 decoding. Espressif ESP32-WROOM-32E 32MBit (4MB)
Bluetooth audio receiver module enclosed in a housing that enables wireless transmission of sounds. It is equipped with a PCB antenna and a 3.5 mm audio jack
The IoT module combining Wi-Fi and Bluetooth (BLE) technologies, which is designed for a wide range of applications, from low-power sensor networks to the most demanding tasks such as voice coding, music streaming and MP3 decoding. Espressif ESP32-WROOM-32D 128MBit
No product available!
Bluetooth 5.0 module based on the BT401 chip. It allows you to send audio and support microSD cards up to 128 GB. DFRobot DFR0781