KAmodBT-HC05 - Bluetooth v2.0 + EDR module with HC-05 system
ID: 557976
5906623432516
zł49.90
Tax included
zł40.57 tax excl.
KAmodBT-HC05 is a Bluetooth module configured via AT commands. It has integrated LEDs indicating operating mode and connection status with the paired device, as well as a logic level translator on UART lines. KAmodBT-HC05
Description
The KAmodBT-HC05 module allows communication with Bluetooth 2.0 devices in master and slave mode. Thanks to the built-in stabilizer and translator of logic levels on the TxD / RxD lines, the module can be used in systems operating in the voltage range from 2.5 V to 5.5 V.
properties
- HC-05 system with integrated antenna, compliant with the Bluetooth v2.0 specification
- UART interface with programmable data rate (baudrate)
- Typical receiver sensitivity: -80 dBm
- Transmitted power level: up to +4 dBm
- Built-in voltage stabilizer
- Possibility of supplying voltage from the range 2.1 - 5.5 V
- Built-in level translator on UART interface lines (TxD, RxD)
- Built-in mode LED (MODE) and pairing device (PAR)
- Built-in button (going into configuration mode)
- The KEY and nRST signals are output to the connector
- Dimensions: 34.2 x 27 x 5 mm
Included
- Assembled module board
- Male 1xpin straight connector (solderable)
[Img-54486-left-large_default]
557976
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
Bluetooth module v2.0 + EDR (master / slave), controlled by AT + commands with built-in antenna.
zł29.52
Delivery date unknown
No product available!
Multifunctional expander (shield) for NUCLEO and Arduino equipped with Bluetooth 2.0+EDR (HC-05) interface, MEMS 3DoF LIS35, LED-RGB, joystick and analog STLM20 temperature sensor developed and produced by KAMAMI.
zł99.00
24h
Available quantity: 36
Available
The module with the HC-05 transceiver makes it easy to add Bluetooth communication to an existing project. The system is controlled by exchanging AT commands (UART bus). FC-114
zł47.05
24h
Available quantity: 16
Available
Other products in the same category (16)
A module that combines GSM/GPRS/GNSS and BT 3.0 technologies. It is available in a small, easy to solder LCC housing and has a low power consumption up to 1.2 mA. Quectel MC60CA
zł107.21
24h
Available quantity: 13
Available
Expansion board with BlueNRG-M0 module compatible with Bluetooth v4.2. It is compatible with the ST morpho connector system (unmounted) and Arduino UNO R3. Communication with the module is via the SPI interface. STMicroelectronics X-NUCLEO-IDB05A2
zł81.67
1 weeks
No product available!
Bluetooth 4.0 module based on the CSR8635 chip designed for Bluetooth audio applications. The module has a built-in antenna and pins for edge connectors.
zł39.09
4 weeks
No product available!
Evaluation kit with Bluetooth 5.0 Sparkfun Artemis module. Equipped with a microphone, kmaers and accelerometer. SparkFun DEV-16828
zł153.80
24h
Available quantity: 1
Available
Bluetooth 5.0 module based on the BT401 chip. It allows you to send audio and support microSD cards up to 128 GB. DFRobot DFR0781
zł17.74
4 weeks
No product available!
Evaluation Kit with Bluetooth 5.0 BT401. It is equipped with a microSD slot, microUSB connector and two audio outputs. DFRobot DFR0782
zł76.76
24h
Available quantity: 1
Available
Development board with LoRa Semtech SX1262 module and Apollo 3 Bluetooth 5 integrated in the NM180100 chip. It supports the 868 MHz and 915 MHz bands and Bluetooth Low Energy. It is compatible with the Qwicc system. SparkFun 17506
zł361.48
3 weeks
No product available!
Bluetooth 5.2 and IEEE 802.15.4 communication kit. It uses the STM32WB55RG microcontroller (1 MB Flash, 256 KB SRAM, ARM® Cortex®-M4 and Cortex®-M0 +). STMicroelectronics NUCLEO-WB55RG
zł177.44
1 weeks
No product available!
Bluetooth audio receiver module enclosed in a housing that enables wireless transmission of sounds. It is equipped with a PCB antenna, microphone, 3.5 mm audio jack and control buttons
zł23.85
24h
Available quantity: 3
Available
Bluetooth audio receiver module enclosed in a housing that enables wireless transmission of sounds. It is equipped with a PCB antenna and a 3.5 mm audio jack
zł12.80
24h
Available quantity: 3
Available
Energy-saving Wi-Fi and Bluetooth 5.0 module compliant with the IEEE 802.11 a/b/g/n/ac standard. Ampak AP6256
zł46.90
4 weeks
No product available!
Bluetooth module with integrated HC-08 system. Thanks to the angular pin connector with the bus signals, it is possible to easily connect the module to the contact plate or wires
zł23.27
4 weeks
No product available!
Powerful, generic Wi-Fi+BT+BLE MCU modules that target a wide variety of applications, ranging from low-power sensor networks to the most demanding tasks, such as voice encoding, music streaming and MP3 decoding. Espressif ESP32-WROOM-32E 32MBit (4MB)
zł19.08
24h
Available quantity: 5
Available
Bluetooth 4.0 BLE module with UART serial interface. Controlled by AT commands, it can be supplied with the voltage from 3.6 V to 6 V. AT-09/HM-10
zł18.45
4 weeks
No product available!
Board with the Artemis chip, the GNSS ZOE-M8Q module and the Iridium 9603N satellite receiver. It allows you to send and receive short messages with data anywhere in the world. SparkFun WRL-18712
zł3,500.97
3 weeks
No product available!
Module with SIM868 designed for GSM, GPRS communication and GNSS positioning. It can communicate within the Bluetooth 3.0 standard. SB Components 21895
zł247.80
24h
Available quantity: 1
Available
KAmodBT-HC05 is a Bluetooth module configured via AT commands. It has integrated LEDs indicating operating mode and connection status with the paired device, as well as a logic level translator on UART lines. KAmodBT-HC05