DFRobot RP-L-170 Thin Film Pressure Sensor

Force-Sensing Resistor - 0.5" Circle

SEN-08685

The SparkFun Load Sensor Combinator is a bare PCB that combines four load sensors into a standard four-wire Wheatstone bridge configuration. BOB-13878

Flexible pressure sensor with dimensions of 400x15 mm. Designed to detect static and dynamic pressure at high reaction speed. DFRobot SEN0299

Round, flexible, pressure sensor that can be used to implement very sensitive force detection. The sensor is durable and designed to detect static and dynamic pressure at high response speeds. DFRobot SEN0295

Educational module for measuring force in the range from 30 g to 1.5 kg, based on a flexible material that responds with a change in the analog signal. Thanks to its small thickness (0.4 mm), fast response and compatibility with Arduino, micro:bit and Unihiker, it is ideal for teaching physics, engineering and DIY projects. DFRobot SEN0616

Deflection sensor 114 mm long. The sensor resistance changes with the bend angle. At the end, the sensor has a 2-pin connector with a pitch of 2.54 mm. SparkFun SEN-08606

A round, flexible, pressure sensor that can be used to realize very sensitive force detection. The sensor is durable and designed to detect static and dynamic pressure at high reaction speed. DFRobot SEN0298

Force-Sensing Resistor - 1.5" Square

Grove module with FSR402 pressure sensor. The board is equipped with a Grove connector with an analog output. Seeed Studio 101020553

Flexible pressure sensor with dimensions of 40 x 40 mm. Designed to detect static and dynamic pressure at high reaction speed. DFRobot SEN0296

Simple-to-use, open source solution for measuring weight and temperature with the ability to read multiple types of load cells and offers a simple-to-use serial menu to configure calibration value, sample rate, time stamp and units of precision. SEN-13261

A simple flex sensor 2.2" in length. As the sensor is flexed, the resistance across the sensor increases. SEN-10264

Set with the ADC HX711 transducer module and a pressure sensor in the form of a tensometric beam. It communicates via the UART interface. It allows you to build a simple home scale. DFRobot SEN0160

This disc load cell (sometimes called a strain gauge) can translate up to a whopping 200kg of pressure (force) into an electrical signal. Each load cell is able to measure the electrical resistance that changes in response to, and proportional of, the strain (e.g. pressure or force) applied to the disc. SEN-13332

M5Stack U177 – Unit Mini Scales is a ready-to-use weighing module based on the HX711 and STM32, featuring I2C communication and support for popular platforms. It is used in laboratory, production and educational projects that require precise mass measurement.