Flexiforce Pressure Sensor - 25lbs (1" area)

Flexible pressure sensor with dimensions of 40 x 40 mm. Designed to detect static and dynamic pressure at high reaction speed. DFRobot SEN0296

Flexiforce Pressure Sensor A201 – 1lb, Tekscan, RoHS

M5Stack U180 module with the HX711 chip enables reading data from weight sensors via I2C, providing precise force and mass measurements in projects based on the M5Stack platform. Ideal for compact weighing and dosing systems.

Long, flexible, pressure sensor that can be used to implement very sensitive force detection. The sensor is durable and designed to detect static and dynamic pressure at high response speeds. DFRobot SEN0293

A simple flex sensor 2.2" in length. As the sensor is flexed, the resistance across the sensor increases. SEN-10264

Grove module with FSR402 pressure sensor. The board is equipped with a Grove connector with an analog output. Seeed Studio 101020553

Force-Sensing Resistor - 1.5" Square

Round, flexible, pressure sensor that can be used to implement very sensitive force detection. The sensor is durable and designed to detect static and dynamic pressure at high response speeds. DFRobot SEN0295

Force-Sensing Resistor - 0.5" Circle

Set with the ADC HX711 transducer module and a pressure sensor in the form of a tensometric beam. It communicates via the UART interface. It allows you to build a simple home scale. DFRobot SEN0160

Round, flexible, pressure sensor that can be used to implement very sensitive force detection. The sensor is durable and designed to detect static and dynamic pressure at high response speeds. DFRobot SEN0297

Educational module for measuring force in the range from 30 g to 1.5 kg, based on a flexible material that responds with a change in the analog signal. Thanks to its small thickness (0.4 mm), fast response and compatibility with Arduino, micro:bit and Unihiker, it is ideal for teaching physics, engineering and DIY projects. DFRobot SEN0616

The SparkFun Load Sensor Combinator is a bare PCB that combines four load sensors into a standard four-wire Wheatstone bridge configuration. BOB-13878

The module allows you to attach a strain gauge (working in the Wheatstone bridge circuit) and convert the analog signal into its digital representation, available on the module output lines. The system processes the signal with a 24-bit resolution and can be powered by 2.7V - 5.5V. The module is especially recommended for constructing digital scales in combination with Arduino

Deflection sensor 114 mm long. The sensor resistance changes with the bend angle. At the end, the sensor has a 2-pin connector with a pitch of 2.54 mm. SparkFun SEN-08606

Force-Sensing Resistor - 0.2" Circle