Tensometric beam with a maximum load of 2 kg

Set with the ADC HX711 transducer module and a pressure sensor in the form of a tensometric beam. It communicates via the UART interface. It allows you to build a simple home scale. DFRobot SEN0160

Force-Sensing Resistor - 0.5" Circle

A round, flexible, pressure sensor that can be used to realize very sensitive force detection. The sensor is durable and designed to detect static and dynamic pressure at high reaction speed. DFRobot SEN0298

Deflection sensor 114 mm long. The sensor resistance changes with the bend angle. At the end, the sensor has a 2-pin connector with a pitch of 2.54 mm. SparkFun SEN-08606

Round, flexible, pressure sensor that can be used to implement very sensitive force detection. The sensor is durable and designed to detect static and dynamic pressure at high response speeds. DFRobot SEN0297

The module allows you to attach a strain gauge (working in the Wheatstone bridge circuit) and convert the analog signal into its digital representation, available on the module output lines. The system processes the signal with a 24-bit resolution and can be powered by 2.7V - 5.5V. The module is especially recommended for constructing digital scales in combination with Arduino

Simple-to-use, open source solution for measuring weight and temperature with the ability to read multiple types of load cells and offers a simple-to-use serial menu to configure calibration value, sample rate, time stamp and units of precision. SEN-13261

Aluminum extensometer beam, allowing measurement of weight up to 20 kilograms. It has four wires. It is used in kitchen scales and portable scales, it has a 21 cm cable, RoHS.

The SparkFun Load Sensor Combinator is a bare PCB that combines four load sensors into a standard four-wire Wheatstone bridge configuration. BOB-13878

Flexiforce Pressure Sensor A201 – 1lb, Tekscan, RoHS

Grove module with FSR402 pressure sensor. The board is equipped with a Grove connector with an analog output. Seeed Studio 101020553

A simple flex sensor 2.2" in length. As the sensor is flexed, the resistance across the sensor increases. SEN-10264

Force-Sensing Resistor - 0.2" Circle

SEN-08685

M5Stack U180 module with the HX711 chip enables reading data from weight sensors via I2C, providing precise force and mass measurements in projects based on the M5Stack platform. Ideal for compact weighing and dosing systems.