Amplifier / signal converter of the extensometer with the HX711 system

This disc load cell (sometimes called a strain gauge) can translate up to a whopping 200kg of pressure (force) into an electrical signal. Each load cell is able to measure the electrical resistance that changes in response to, and proportional of, the strain (e.g. pressure or force) applied to the disc. SEN-13332

A simple flex sensor 2.2" in length. As the sensor is flexed, the resistance across the sensor increases. SEN-10264

Force-Sensing Resistor - 0.2" Circle

Module with a deflection sensor with two measuring probes. The board houses the ADS1015 converter, which is an ADC converter with an output in the form of an I2C interface. SparkFun SEN-14666

The SparkFun Load Sensor Combinator is a bare PCB that combines four load sensors into a standard four-wire Wheatstone bridge configuration. BOB-13878

M5Stack U180 module with the HX711 chip enables reading data from weight sensors via I2C, providing precise force and mass measurements in projects based on the M5Stack platform. Ideal for compact weighing and dosing systems.

Force Sensor, 1,5kg, Honeywell, RoHS

Force-Sensing Resistor - 0.5" Circle

Flexible pressure sensor with dimensions of 400x15 mm. Designed to detect static and dynamic pressure at high reaction speed. DFRobot SEN0299

A round, flexible, pressure sensor that can be used to realize very sensitive force detection. The sensor is durable and designed to detect static and dynamic pressure at high reaction speed. DFRobot SEN0298

Educational module for measuring force in the range from 30 g to 1.5 kg, based on a flexible material that responds with a change in the analog signal. Thanks to its small thickness (0.4 mm), fast response and compatibility with Arduino, micro:bit and Unihiker, it is ideal for teaching physics, engineering and DIY projects. DFRobot SEN0616

Flexiforce Pressure Sensor A201 – 1lb, Tekscan, RoHS

Grove module with FSR402 pressure sensor. The board is equipped with a Grove connector with an analog output. Seeed Studio 101020553

Aluminum tensometer beam, allowing weight measurement up to 2 kilograms. It has four wires. It is used in kitchen scales and portable scales.

Force-Sensing Resistor - 1.5" Square

Flexible pressure sensor with dimensions of 40 x 40 mm. Designed to detect static and dynamic pressure at high reaction speed. DFRobot SEN0296