M5Stack SERVO2 - 16-channel servo controller

A set for building a walking robot. The chassis is equipped with four servos, a controller and an STM32F030 microcontroller. M5Stack U086

Prototyping kit designed for sets from the M5ATOM series. It includes two boards with 60 prototyping fields and the necessary connectors. M5Stack A077

Module with a PIR motion sensor designed for M5Stack modules. It can detect movement up to 5 meters with a detection angle of 100 degrees. M5Stack U004

ATOM Lite development kit complete with programmable AC/DC HUB switch module. M5Stack ATOM SWITCH

M5Stack A131 is a single-port TTL–RS485 converter with built-in 12 V power supply, enabling reliable RS485 communication and powering of M5ATOM devices in compact embedded systems and industrial automation applications.

M5Stack A144 module with the StampS3 chip and I2C interface serves as a compact prototype board for integrating IoT systems and testing communication with peripheral devices. It is designed for rapid deployment of communication solutions in projects based on the M5Stack platform.

The ESP32-H2 Gateway Unit with ZigBee, Thread, and Matter support enables the development of energy-efficient IoT applications and the integration of intelligent systems. Designed to operate as a gateway or end node in wireless networks based on the IEEE 802.15.4 standard. M5Stack U195

M5Stack K145 (Tab5) is a compact IoT terminal with RS-485 and GPIO interfaces, based on a dual-processor architecture, designed for deployment in smart automation systems and mobile applications. It offers the flexibility and performance required for advanced development projects.

MEMS SPM1423 digital microphone module with PDM modulation. It communicates via the I2S interface. M5Stack U089

The module with SSR BT136S relay with a load of up to 2 A, designed for M5Stack sets. The board is equipped with a Grove connector and is controlled by a digital input. M5Stack U122

Module with a 433 MHz radio receiver for M5Stack sets. Based on the SYN531R chip, it has a built-in PCB antenna. M5Stack U113

Isolated UART-RS485 converter designed for M5Stack sets. It allows communication within an industrial serial interface. M5Stack U094

Module with three Hall sensors A3144E, which react to the failure of the magnet. It is powered with 5 V and has a digital output on the Grove connector. M5Stack U084

12-bit DAC converter module designed to work with the M5Stack sets. It enables the conversion of digital signals into an analog signal. M5Stack DAC Unit

DC-DC Step-Down Converter ME3116AM6G with an output voltage of 5 V, input voltage from 6 to 24 V and a maximum output current of 1 A. Dedicated to the M5Stack modules. M5Stack U125

RS485 converter designed for sets from the M5ATOM series. It allows you to connect to development kits devices controlled by the RS485 bus. M5Stack T002