Handheld RFID card reader (duplicator)

The X-NUCLEO-NFC02A1 is a dynamic NFC/RFID tag board based on M24LR04E-R, for expansion of STM32 Nucleo boards

NFC module designed for Arduino. Meets the standards of reader mode, P2P mode and card emulation mode. The board has an integrated RF antenna. NXP OM5578/PN7150ARDM

Module with RFID reader. It is equipped with a buzzer and communicates via UART or USB interface. SB Components 20669

A small key ring with an RFID tag for systems operating at 125 KHz. Provides the ability to read and write a unique ID number

Module with an RFID reader designed to work with the Raspberry Pi. Equipped with an OLED display and a buzzer. SB Components 20003

WRL-14147

KAmodNFC is an expansion board with M24LR64E-R chip – dynamic tag with 64kb EEPROM memory and dual communication interface (I2C/RF). On board is placed also signalization of energy harvesting function, which is in M24LR64E-R chip embedded.

Intelligent RFID identifier cooperating with iNode Control Point

A set of RFID tags consisting of three key rings in different colors and two white cards. The tags operate at 125 kHz and comply with the EM4100 standard. Seeed Studio 110990035

The tag contains a NXP S50 chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away. These can be read by almost any 13.56MHz RFID/NFC reader. Adafruit 360

Card with RFID tag for systems operating at 125 KHz. Provides the ability to read and write the ID number

Module with an RFID tag based on the ST25DV16K chip. It can be reprogrammed via the I2C bus. Equipped with STEMMA QT connector and PCB antenna. Adafruit 4701

ID Card Key for 125khz

Intelligent relay cooperating with iNode Control ID

Adafruit 364

Module with RFID reader designed to work with micro:bit. It is equipped with a buzzer and can control two modeling servos. SB Components 21291