CLRC66303HNE

Intelligent RFID identifier cooperating with iNode Control Point

The RFID / NFC transponder reader module (tags) works in the PN532 chip and is compatible with Arduino. Data is available via SPI, I2C or HSU (High Speed UART). Supplied with a RFID card and key ring. ELECHOUSE NFC MODULE V3

Intelligent relay cooperating with iNode Control ID

Module with RFID reader designed to work with micro:bit. It is equipped with a buzzer and can control two modeling servos. SB Components 21291

Intelligent RFID identifier cooperating with iNode Control Point

The tag contains a NXP S50 chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away. These can be read by almost any 13.56MHz RFID/NFC reader. Adafruit 360

Module with an RFID reader designed to work with the Raspberry Pi Pico. Equipped with an OLED display and a buzzer. SB Components 21192

WRL-14147

Module with RFID reader. It is equipped with a buzzer and communicates via UART or USB interface. SB Components 20669

A set of RFID tags consisting of three key rings in different colors and two white cards. The tags operate at 125 kHz and comply with the EM4100 standard. Seeed Studio 110990035

A small key ring with an RFID tag for systems operating at 125 KHz. Provides the ability to read and write a unique ID number

RFID tag for systems operating at 125 KHz. Provides the ability to read and write a unique ID number

NFC module designed for Arduino. Meets the standards of reader mode, P2P mode and card emulation mode. The board has an integrated RF antenna. NXP OM5578/PN7150ARDM

Handheld RFID card reader enabling card duplication. It allows you to read data from one card and write it to the other

The X-NUCLEO-NFC02A1 is a dynamic NFC/RFID tag board based on M24LR04E-R, for expansion of STM32 Nucleo boards

NFC/RFID tag equipped with ST25DV64KC NFC/RFID tag from STMicroelectronics. The chip offers a 64-kbit (8-byte) EEPROM. Complies with ISO/IEC 15693 or NFC Forum Type 5. SparkFun SEN-21274