Fermion: SHTC3 Temperature & Humidity - module with SHTC3 humidity and temperature sensor

Module with DHT20 temperature and humidity sensor. It allows you to measure humidity in the range from 0 to 100% and temperature from -40 to 80℃. DFRobot SEN0497

Module with pressure, temperature and humidity sensor BME280. It allows to read the atmospheric pressure in the range from 300 to 1100 hPa and communicates via the I2C or SPI interface. Waveshare BME280 Environmental Sensor

Module with temperature and humidity sensor DHT11. It allows you to measure humidity in the range of 20 ... 90% and temperature (0 ... 50 ° C). DFRobot DFR0067

I2C BME680 Environmental Sensor is a gas, pressure, temperature and humidity sensor in one MEMS housing. The module is supplied with 3.3-5V, for communication the I2C or SPI interface is used. DFRobot SEN0248

Digital temperature and humidity sensor with calibrated digital output signal. Equipped with a 2.5 mm 4-pin male stereo audio connector that works perfectly with the Sonoff TH10/TH16 socket. Sonoff Si7021

Module with CO2, temperature and humidity sensor SCD-41. Equipped with a Qwiic/STEMMA QT connector, it communicates via the I2C interface. Pimoroni PIM587

Adafruit module with Si7021 temperature and humidity sensor. Sensor Sillicon Labs can measure temperature in the range of -10 ~ 125 ° C, and humidity in the range of 0-100 & RH. The sensor communicates using the I2C interface. Adafruit 3251

 relative humidity sensor with integrated temperature sensor for highly accurate measurements at low power. With the TI HDC1080, you can determine the relative humidity of the environment with up to 14 bits of resolution. Digilent 410-347

Integrated BME688 gas, pressure, temperature and humidity sensor in one MEMS housing. The system can be supplied with the voltage of 3.3 V and is equipped with an I2C communication interface. BME688 Breakout Board

Module with sensors of environmental parameters. It allows you to measure temperature, humidity and pressure as well as CO2 and VOC concentration. DFRobot SEN0335

Module with pressure, temperature and humidity sensor BME280. It allows to read the atmospheric pressure in the range from 300 to 1100 hPa and communicates via the I2C interface. Pimoroni PIM472

Module with BME280 environmental sensor. It allows you to measure temperature, humidity and pressure. The sensor is equipped with two communication interfaces: SPI and I2C (Qwiic). SparkFun SEN-15440

The AM2315C is an advanced packaged temperature and humidity sensor offering easy integration with microcontrollers thanks to its 2.5V-5.5V power supply and standard I2C interface, providing greater resistance to external conditions than typical SHT sensors, with measurement accuracy of ±2% RH and ±0.3°C

Analogue temperature and humidity sensor module based on SHT30 sensor. It is characterized by high reliability and stability with low energy consumption. It is compatible with 3.3V and 5V controllers, such as Arduino, micro:bit, ESP32. DFRobot DFR0588

Module with a BME680 sensor that allows you to measure temperature, humidity, pressure and gas detection. The board is equipped with a Grove connector and communicates via I2C and SPI. Seeed Studio 101020513

Module with DHT20 sensor. It allows you to measure humidity in the range from 0 to 100% and temperature from -40 to 80 ℃. Seeed Studio 101020932