List of products by brand DFRobot

Data logger with USB protocol support. Data received through the UART interface and saved on the microSD card. Supports cards with a capacity of up to 32 GB. DFRobot TEL0148

Radio receiver module operating at 433 MHz. It is equipped with Gravity connectors and communicates via a digital interface. DFRobot TEL0142

A module with a MEMS microphone that will allow you to detect a voice, a clap or a door slam. The board has an analog output. DFRobot SEN0487

Water pressure sensor with 3-pin Gravity interface. It enables the measurement of liquid pressure in the range from 0 to 1.6 MPa. It is supplied with the voltage of 5 V and has a linear output voltage from 0.5 to 4.5 V. DFRobot SEN0257

Gravity module with a colored RGB WS2812 LED. Thanks to the controller built into the diode, you can connect the modules in series and control all with one microcontroller port. DFRobot DFR0605

Dreamer Nano V4 - Arduino Leonardo compatible; ATmega 32U4

8-port I2C splitter module. The board is equipped with a Gravity connector and allows you to connect additional I2C devices. DFRobot DFR0759

Module with MLX90614-DCC sensor for non-contact temperature measurement in the range from -70℃ to 380℃. I2C communication. DFRobot SEN0206

Radio transmitter module operating at 433 MHz. It is equipped with Gravity connectors and communicates via a digital interface. DFRobot TEL0140

SEN0162 This UV Sensor with GUVA-S12SD chip is suitable for detecting the UV raditation in sunlight. It can be used in UV Index Monitoring, DIY project, UV-A Lamp Monitoring, Plants growing Environmental monitoring...etc.

A digital precision current sensor module that measures voltage, current and power of electronic modules and devices up to 26V and 8A with a relative error of ± 0.2%. DFRobot SEN0291

(DFR0009) LCD Keypad Shield for Arduino

A round, flexible, pressure sensor that can be used to realize very sensitive force detection. The sensor is durable and designed to detect static and dynamic pressure at high reaction speed. DFRobot SEN0298

Switch module with an interlock. DFRobot DFR0423

Carrier board dedicated to Raspberry Pi CM4 modules. It is equipped with two Ethernet connectors, a microSD slot and a USB connector. It allows you to build a small router. DFRobot DFR0767

A DIY spider robot that you can expand according to your own taste and ideas. There are two mounting options allowing you to change the stride length and gait of the spider. DFRobot ROB0103

An offline speech recognition module that enables recognition and interpretation of user spoken commands without access to an external pattern database. It is equipped with 121 commonly used fixed command words and the ability to learn up to 17 new customised instructions. DFRobot SEN0539-EN

Gravity: I2C 12-Bit DAC is a module with 12-bit DAC and built-in EEPROM memory. The module is powered by 3.3 ... 5V for communication used by the I2C interface. DFRobot DFR0552

An expansion board designed for the Raspberry Pi Pico. The board has 13 GPIO pins, 3 ADCs, UART, I2C and SPI interfaces. The pins are color coded according to the Gravity standard. DFRobot DFR0848

A module with a 16-channel input/output port expander controlled by an I2C interface. It was based on the MCP23017 chip and equipped with a Gravity connector. DFRobot DFR0626