List of products by brand Inny

40-pin male angled socket, 2.54mm pitch, DC3, dual-row, for IDC connector. IDC-40P-A.

Development board D1 Mini with WiFi module ESP-8266MOD and 4 MB Flash memory. The module can be programmed from the Arduino IDE level. WeMos D1 Mini

Adapter with 3.3V voltage regulator designed for NRF24L01 modules with 8-pin connector

12-wire cable, 10 cm long, with a micro 5264 female plug at both ends

11-wire cable, 10 cm long, with a micro 5264 female plug at both ends

Set of 10 pcs. Male-male black male cables, 15 cm long, for contact plates. CAB_M-M (BK-10-15)

7-wire cable, 10 cm long, with a micro 5264 female plug at one end

6-wire cable, 10 cm long, with a micro 5264 female plug at both ends

Expander designed for Wemos D1 Mini boards. Allows you to extend the Wemos pins to additional connectors and connect expansion modules

LED 3 mm YELLOW 590nm "MILK", angle 60; light intensity 160 mcd (20mA) (type 2.1V)

Tip 900M-T-1C beveled to the station AOYUE ZHAOXIN REPRO YIHUA PT WEP black from ZHAOXIN

A module with EEPROM memory with a capacity of 256Kbit (32kB) with the AT24C256 chip in the SMD version. It communicates via the I2C interface

Threaded pipe used to connect the heat sink and heating block, contains a Teflon tube in the middle, adapted to a 1.75 mm filament

Female terminal block, 4-pin. Pitch 5.0mm. Height 15mm. 2EDGK-5.0-4P. Set of 5 pieces

Female terminal block, 7-pin. Pitch 3.5mm. Height 7.8mm. Suitable for KF2EDGR male strips with a pitch of 3.5 mm. 2EDGKN-3.5

Needle bending needle, for precise glue application, Flux 1.60mm internal diameter and 2,108mm outside diameter. Set of 5 pcs

Female terminal block, 3-pin. Pitch 5.0mm. Height 15mm. 2EDGK-5.0-3P. Set of 5 pieces

Plug housing, 2x4, 2.54mm, for wire, RoHS. Set of 20 pieces

Male terminal block, angled, 3-pin. Pitch 3.81mm. Height 7mm. 15EDGRC. Set of 10 pieces

Dispensing needle for precise application of glue, flux with an internal diameter of 0.6mm and an external diameter of 0.89mm. Set of 5 pcs