List of products by brand Inny

Brush for cleaning nozzles in 3D printers. Made of brass wire, it facilitates the maintenance and service of 3D printers

UART-CAN converter module based on the TJA1050 transceiver system. It allows for communication, for example, of a microcontroller via the CAN bus

Nozzle designed for 3D printers with a Volcano hotend. It is much longer than standard V6 nozzles, which makes it possible to achieve higher print speeds

Antenna with RP-SMA male plug operating in the 433 MHz frequency band. It has a gain of 5 dBi. Included with RP-SMA - u.FL adapter

Nozzle designed for 3D printers with a Volcano hotend. It is much longer than standard V6 nozzles, which makes it possible to achieve higher print speeds

The 2.1x5.5mm DC Power Jack female plug is a reliable 90-degree power connector, perfect for use in monitoring systems and LED lighting. ADP0036

7-segment LED display, 1 digit 20.40mm, two dots, dark green (517nm), 15000 ucd (10mA), common anode, Pb-free. LED1-AS-B-08012BPG

Neodymium rectangular magnet with dimensions of 12x5mm a and a height of 5 mm. Set of 10 pcs

USB cable (type A) - microUSB (type B) used to connect the computer with devices equipped with microUSB-B sockets. Length: 1m

Female terminal block, 6-pin. Pitch 3.5mm. Height 7.8mm. Suitable for KF2EDGR male strips with a pitch of 3.5 mm. 2EDGKN-3.5

Green LED (520nm) with 1W power equipped with a heat sink. Brightness approx. 70lm, viewing angle 120 degrees.

Neodymium rectangular magnet with dimensions of 15x6mm a and a height of 3 mm. Set of 10 pcs

Dispensing needle for precise application of glue, flux with an internal diameter of 1.5mm and an external diameter of 1.8mm. Set of 5 pcs

Neodymium rectangular magnet with dimensions of 15x6mm a and a height of 5 mm. Set of 5 pcs

10 cm 3-pin cable with JST PH2.0 female plug to 2.54 mm 3-pin female goldpin

A connector that allows you to connect the cable to the existing installation without having to cut the cable. Suitable for wires with a cross-section of 0.5-1.5mm2

A small USB-UART TTL converter module based on the CH340E chip with a microUSB connector

Case for two 18650 batteries connected in series (7.4 V). Equipped with a flap and a switch

DVB-T digital TV tuner for a PC computer, including an internal antenna, remote control and multimedia software. The receiver is based on the RTL2832U system and the 820T2 head, thanks to which it can be program controlled.