List of products by brand Inny

7-segment LED display, 1 digit of 56.80mm, red (660nm), 20mcd (10mA), common anode, Pb-free. LED1-AS-B-23011BMR

A set of colored markers for wires with a cross-section of 2.5 mm². Each tag is labeled with a number for easy identification of the cable bundles. 100 pieces

Micro analog servo with metal gear. It has a range of motion of 145°. EMAX ES08MA

T13 soldering tip with a BL-type sharp tip designed for the Bakon BK950D station

Male terminal block, angled, 5-pin. Pitch 5.0mm. Height 7.8mm. 2EDGRC-5.0-5P. Set of 10 pieces

Male terminal block, angled, 7-pin. Pitch 5.0mm. Height 7.8mm. 2EDGRC-5.0-7P. Set of 5 pieces

LT86104UX is an advanced HDMI 2.0 controller that enables splitting a single HDMI signal into four outputs. Thanks to support for 4K resolution, high data transmission speed, and built-in signal quality enhancement features, the device is used in AV equipment, digital signage systems, and multi-display solutions.

Audio module designed for Teensy 4.0 and 4.1. It uses the SGTL500 audio codec chip with I2S interface, it can work with a microSD card or SPI Flash memory. Audio Adapter Boards for Teensy 4.x (Rev D)

Female terminal block, 3-pin. Pitch 5.0mm. Height 15mm. Suitable for 2EDGRC male strips with a pitch of 5.0 mm. 2EDGKD-5.0-03P

Anti-magnetic tweezers, straight, sharp, made of stainless steel, resistant to corrosion of most solvents and cleaning agents

Adapter for 20/14/10-pin JTAG. It allows to connect the JTAG programmer to a evaluation boards which uses various standards of the programming connector. IDC20, IDC14, IDC10 and JST-XH sockets are available.

The 624ZZ bearing is a small, precision deep groove ball bearing with dimensions of 4×13×5 mm (inner diameter × outer diameter × thickness). It features double metal shields that protect against dust and small contaminants, although they are not fully waterproof. A set of 10 pieces is ideal for use in model making, 3D printers, small electric motors, or guide rollers. These bearings are typically made of chrome steel, providing good durability and wear resistance.

TSL12122, Tact Switch 12x12 with LED, TACT 12x12

Holder for attaching the glass to the 3D printer table in the form of a clamp clip

Module with an analog MQ2 gas sensor. It enables the detection of LPG, butane, propane, methane, alcohol, hydrogen and smoke. It is powered with the voltage of 5 V and has an analog output

The 128×64 graphic display with black text and white ECO backlight provides an energy-efficient, compact solution for projects requiring a clear and legible interface. It is suitable for industrial, measurement, and embedded applications where small size, low power consumption, and easy installation are important.

Nozzle with a diameter of 0.6 mm and an MK8 thread compatible with most hotends used in 3D printers. Designed for filaments with a diameter of 1.75 mm. Made of hardened steel, making it ideal for printing using filaments with additives such as metals, carbon fibers, glass fibers and graphene.

Module with 4-digit 7-segment display. The board is equipped with a TM1637 driver and communicates via a digital interface

Female terminal block, 5-pin. Pitch 5.0mm. Height 15mm. 2EDGK-5.0-5P

Module with a PIR motion sensor. It can detect movement up to 5 meters with a detection angle of 120 degrees