List of products by brand Inny

A universal oscilloscope probe with a BNC connector and a 10:1 voltage divider. It has a frequency response of 200 MHz and allows measurements with a maximum voltage of up to 600 V. Hantek PP-200

The converter module converts the voltage in the range of 3-7.2V to 200KV with an efficiency of over 90%. It is compact with dimensions of 24 x 64 mm and operates in temperatures from -40°C to 85°C.

Laser distance sensor with a measuring range up to 4 m based on the ToF measurement technique. Communication with the module takes place via the I2C interface

Rectifier diode Schottky, THT, 40V, 1A, DO-41, LGE, RoHS. Set of 10 pieces

6-pin male angled socket, 2.54mm pitch, DC3, dual-row, for IDC connector. IDC-6P-A.

Female terminal block, 10-pin. Pitch 5.0mm. Height 15mm. Suitable for 2EDGRC male strips with a pitch of 5.0 mm. 2EDGKN-5.00

The stepper motor driver with Allegro A4988 (A4988 Stepper Motor Driver Carrier) allows you to supply a bipolar current of up to 2A per phase. The system can be supplied with voltage up to 35V, in the set there is a heat sink. It is compatible with Polol 1182

AB type flexible cable (tape), 20 cm long. The tape has 10 wires and a pitch of 1mm

FPC/FFC 6-pin adapter with 0.5mm pitch for DIP holes 2.54mm pitch.

3-wire cable, 10 cm long, with a micro 5264 female plug at one end

FPC/FFC 50-pin adapter with 0.5mm pitch for DIP holes 2.54mm pitch.

IC socket in DIP24N package, 24-pin, 2.54 mm pitch, 7.62 mm pitch, RoHS

USB port isolator based on the ADUM3160 chip with 4 output ports. The device has a rated insulation voltage of 1500V. The isolator is powered from the USB port or external power supply.

A 20 cm long 6-pin cable with a JST XH2.5 male plug on one side

Membrane keypad module with 4 buttons. It is equipped with a tape terminated with a 5-pin connector

Needle bending needle, for precise glue application, Flux 0.337mm internal diameter and 0,6414mm outside diameter. Set of 5 pcs

Prototyping circuit board designed for Wemos D1 Mini boards

Solder alloy Sn60Pb40 with a diameter of 1.0 mm and a weight of 100 g intended for soldering work in electronics and electrical engineering. It is used for mounting standard through-hole components, repairs, and soldering surfaces with various metallic coatings. The alloy composition provides good wettability and conductivity, which translates into durability and quality of solder joints.

THT resistor, 0.5W, 1%, RoHS