List of products by brand Inny

Kynar type cable with a diameter of 0.25 mm (30 AWG) and a length of 180 m. Used for connections in electronic devices, e.g. on PCB

2-pin ARK mounting strip, 5.0 mm pitch. 103-5.0-02P-14-00A(H). Set of 10 pieces

The SMD soldering learning kit is an ideal tool for electronics beginners, enabling practical mastery of surface assembly techniques. By offering a variety of components, it allows you to experiment with soldering parameters and gain valuable experience.

Female terminal block, 11-pin. Pitch 5.0mm. Height 15mm. Suitable for 2EDGRC male strips with a pitch of 5.0 mm. 2EDGKN-5.00

Matrix with 16 WS2812B RGB diodes controlled by a serial signal. The module can be powered with 5V, only one signal line is required for control

Momentary button, monostable (Tact Switch), dimensions 12x12 mm and 7.3 mm high, yellow, with 4-pins

A connector that allows you to connect the cable to the existing installation without having to cut the cable. Suitable for wires with a cross-section of 0.5-1.5mm2

Dispensing needle for precise application of glue, flux with an internal diameter of 1.5mm and an external diameter of 1.8mm. Set of 5 pcs

Cable that allows you to attach the ATMEL-ICE programmer to the development kit with any connector (supported by the programmer), via single pin plugs (goldpin)

SIM card connector, push-push; for SMD surface mounting.

Electromagnetic relay with a single SPDT (1 Form C) changeover contact and a rated coil voltage of 12 V DC. The contacts can switch loads up to 10 A at 250 V AC or 30 V DC. Designed for through-hole PCB mounting. HF118F/012-1ZS1T

Needle bending needle, for precise glue application, Flux 0.84mm internal diameter and 1,26mm outside diameter. Set of 5 pcs

3-pin ARK mounting strip, 5.0 mm pitch. 301-5.0-03P-12-00A(H)-BC. Set of 10 pieces

Male terminal block, angled, 4-pin. Pitch 5.0mm. Height 7.8mm. 2EDGRC-5.0-4P. Set of 10 pieces

150 W Step-Up converter with an output voltage of 15to 35 V, an input voltage of 10 to 32 V and a maximum current of up to 6 A

GY-9250 is a 9 Degrees of Freedom (9DoF) module with the InvenSense MPU-9250 chip. It has a built-in gyroscope, accelerometer and magnetometer.

Bluetooth module with built-in CC2541 chip. The module is small, energy-saving and easy to use

Nozzle designed for 3D printers with a Volcano hotend. It is much longer than standard V6 nozzles, which makes it possible to achieve higher print speeds

Kynar type cable with a diameter of 0.25 mm (30 AWG) and a length of 180 m. Used for connections in electronic devices, e.g. on PCB