LPC2378FBD144

LPC2378FBD144
Mikrokontroler z rdzeniem ARM7TDMI

• 512 kB on-chip Flash Program Memory with In-System Programming (ISP),
• 32 kB of SRAM on the ARM local bus for high performance CPU access.
• 16 kB SRAM for Ethernet interface. Can also be used as general purpose SRAM.
• 8 kB SRAM for general purpose DMA use also accessible by the USB.
• Ethernet MAC with associated DMA controller. These functions reside on an independent AHB bus.
• USB 2.0 Full-Speed Device with on-chip PHY and associated DMA controller.
• Four UARTs with fractional baud rate generation, one with modem control I/O, one with IrDA support, all with FIFO.
• CAN controller with two channels.
• SPI controller.
• Two SSP controllers, with FIFO and multi-protocol capabilities. One is an alternate for the SPI port, sharing its interrupt and pins. These can be used with the GPDMA controller.
• Three I2C-bus interfaces (one with open-drain and two with standard port pins).
• I2S (Inter-IC Sound) interface for digital audio input or output. It can be used with the GPDMA.
• Secure Digital (SD) / MultiMediaCard (MMC) memory card interface.
• 104 General purpose I/O pins with configurable pull-up/down resistors.
• 10-bit ADC with input multiplexing among 8 pins.
• 10-bit DAC.
• Four general purpose Timers/Counters with 8 capture inputs and 10 compare outputs. Each Timer block has an external count input.
• One PWM / Timer block with support for three-phase motor control. Each PWM has two external count inputs.
• Real Time Clock with separate power pin, clock source can be the RTC oscillator or the APB clock.
• 2 kB SRAM powered from the RTC power pin, allowing data to be stored when the rest of the chip is powered off.
• Watchdog Timer. The watchdog timer can be clocked from the internal RC oscillator, the RTC oscillator, or the APB clock.
• Standard ARM Test/Debug interface for compatibility with existing tools.
• Emulation Trace Module supports real-time trace.
• Single 3.3 V power supply (3.0 V to 3.6 V).
• LQFP144.

Uwaga! W naszej ofercie są dostępne stabilizatory LDO 3,3 V.

	Datasheet
	LPC2364/2366/2368?2378 User Manual