KAmodCSIextender modules are designed to work with Raspberry Pi cameras. KAmodCSIextender allows you to extend the signal from cameras using the HDMI <-> HDMI cable (up to 10 meters).

Debugger/programmer with a USB interface that supports the SWD (Serial Wire Debbug) programming interface. It is based on CMSIS-DAP (Coresight Debug Access Port) and also has a USB-UART converter function

Base board for dipPLD modules with XC2C256 (CoolRunner-II by Xilinx)

JTAG interface for microcontrollers with ARM core

LED matrix display module (in blue color) with an organization of 14 columns x 9 lines, compatible with Arduino.

LED matrix display module (in green color) with an organization of 14 columns x 9 lines, compatible with Arduino.

8-position DIP-Switch Module

The SMD soldering kit is a great educational tool for beginners in electronics, which allows you to gain practical skills in surface mounting components. The set includes a high-quality printed circuit board and a variety of SMD components, allowing you to experiment and learn soldering, and the end result of correct assembly is a red LED lighting up

The board with the RP2040 microcontroller equipped with two ARM Cortex-M0 + cores operating at a frequency of 133 MHz, 264 kB RAM. There is as much as 16 MB of QSPI flash memory on the board. The system can be programmed in C / C ++ or microPython. KApico RP2040

Pressure sensor module with I2C interface (MPL115A2)

Universal board for ZL40ARM and ZL41ARM kits

ZL2PRG is an AVR microcontroller programmer compatible with STK200 with a standard 10-pin ISP connector. The programmer is powered from the programmed system (3-5V). The set also includes a housing.

Development kit with STM32L496ZGT6 microcontroller (ARM Cortex-M4 core) with a built-in ST-Link programmer. Extensive equipment, including: MEMS 6DoF sensor, motor controller, joystick, LED display, 8 LED diodes, RGB LED, audio amplifier, Flash memory QSPI 1 MB, microphone, Arduino connector

Evaluation Board for dipAVR Mini-module

Evaluation board with STM32 microcontroller and built-in ST-Link porgrammer/debugger

A set of elements that allow you to create fascinating projects, both simple and more advanced. The set includes, among others contact plate, wires, passive elements or the well-known NE555 timer system

Modern SSDs are most commonly equipped with a high-speed NVMe interface, implemented through an NGFF connector with an M-key, known as M.2 M-key. The KAmod USB-PCIE-M2 adapter allows you to connect an M.2 M-key SSD to a computer via a USB port.

Development kit for STM32F107VCT6 microcontrollers, equipped with e.g. a joystick, 4 LEDs, USB host and device, Ethernet module connector, RS232 connector

KAmodQTR8A is a module with eight photointerrupter sensors KTIR0711S. It allows to detect edge or line. Thanks to the analog outputs, is possible to connect a module to the e.g. comparator. The module can be used in analisze of the floor e.g. by Linefollower vehicles.