ZL33PRG – SWD programmer-debugger for ARM core microcontrollers

JTAG/SWD debug probe with USB interface. Based on a 32-bit RISC CPU, it can communicate at high speed with the supported target CPUs. J-Link is used around the world in tens of thousand places for development and production (flash programming) purposes. J-link PLUS Compact (8.19.28)

10-wire ribbon cable (1.27mm to 2.54mm) for Segger J-Link EDU mini

A new programmer-debugger with the USB interface. It supports the STM32 microcontrollers via SWD interface. ZL30PRGv2-1 is compatible with the STMicroelectronics ST-Link/V2-1. It also has the function of USB-UART converter, thanks to which it can successfully replace the KAmodRS module.

Hi-Speed JTAG/SWD Emulator for ARM7/9, Cortex and Renesas RX cores with USB interface, Segger

The STLINK-V3SET is a modular stand-alone debugging and programming probe for the STM8 and STM32 microcontrollers. It is composed of a main module and a complementary adapter board

J-Link BASE is a USB powered debug probe supporting a large number of CPU cores. Based on a 32-bit RISC CPU, it can communicate at high speed with the supported target CPUs. J-link BASE Compact (8.19.00)

Compact programmer module for STM32 microcontrollers for soldering into a board. Supports JTAG/SWD interfaces. STLINK-V3SET has a virtual COM port and interfaces SPI, I2C, CAN, GPIO for programming via bootloader. STMicroelectronics STLINK-V3MODS

Hi-Speed JTAG/SWD Emulator with USB and Ethernet interface, Segger

J-LINK EDU Mini is a version of the J-Link EDU (8.08.90) in a reduced form factor with identical functionality for Cortex-M based targets. It has been designed to allow students and educational facilities as well as hobbyists access to top of the line debug probe technology. Version for non-commercial use only. J-Link EDU mini

An adapter dedicated to programming STM32 microcontrollers in QFP100 chassis. It has a 20-pin JTAG/SWD connector and/or a 4-pin USART1 interface for programming and testing. Waveshare STM32-QFP100

JTAG / SWD programmer-debugger with USB and WiFi interface. It supports microcontrollers and microprocessors with Cortex-M, Cortex-A, Cortex-R and ARM7, ARM9 and ARM11 cores of most manufacturers as well as 8051, RISC-V, PIC32, RX. Segger J-Link WiFi (8.14.28)

JTAG/SWD Emulator for ARM7/9, Cortex and Renesas RX cores with USB interface, Segger

Versatile, low-cost debugger and programmer for 8-bit and 32-bit microcontrollers

JTAG/SWD Emulator with USB interface

JTAG interface for microcontrollers with ARM core