STK600 - uniwersalny zestaw uruchomieniowy AVR

The Atmel AVR® STK600 is a complete starter kit and development system for the AVR and AVR32 flash microcontrollers from ATMEL Corporation. It is designed to give designers a quick start to develop code on the AVR, combined with advanced features for using the starter kit to prototype and test new designs. STK600 is shipped with a ATmega2560 device board.

Socket and adapter boards are available for the whole range of AVR's, from 8- to 144-pins devices (tinyAVR, megaAVR, AVR XMEGA and AVR32 UC3). The socket and adapter boards must be bought separately (board with an ATmega2560 microcontroller is included).

Visit the STK600 Socket Package Selection Guide to find the right expansion module for your device.

The AVR Studio and AVR32 Studio online-help contains the most current information and a complete list of supported devices.

Key Features:

• AVR Studio 4/AVR32 Studio compatible
• USB Interface to PC for programming
• Control Powered from USB bus or from an external 9-15 V DC power supply
• Parallel and Serial High-Voltage Programming of AVR devices
• Serial In-System Programming (ISP) of AVR devices
• JTAG programming of AVR and AVR32 devices ISP
• JTAG programming of AVR devices in external target systems Flexible routing
• Socket card system for easy mounting of all supported devices
• 8 push-buttons for general use
• 8 LEDs for general use
• All AVR I/O ports easily accessible through pin header connectors
• Expansion connectors for plug-in modules
• Prototyping area On-board 2 Mbit Dataflash for non-volatile data storage
• USB mini-AB (On-The-Go) connector for USB devices
• PHY and DSUB-9 connetor for RS232 interface
• PHY and DSUB-9 connector for CAN bus
• PHY and header for LIN bus
• Device board with an ATmega2560 AVR microcontroller is included
  (Note: Socketcards and routingcards must be bought separately.)

Content:

• STK600 starter kit evaluation board
• Cables for STK600:
  • Two 10-wire cables for I/O ports and Parallel mode programming
  • One 6-wire cable for In-System Programming
  • Four 2-wire cable for UART and dataflash connections
• USB cable
• DC power cable
• Atmel CD-ROM with datasheets and software
• Device board with an ATmega2560 AVR device
• Two sets of screws and nuts, and one set of clips