- Obecnie brak na stanie
 
        
          Tamiya Connector Pack, Female
This style of high-current connector is commonly used with the 7.2V sub-C battery packs that power many RC cars. The connector is keyed so that power cannot be reversed, and a latch secures the connection so that it will not become disconnected. You can use a crimping tool to attach these connectors to your own 14- to 20-AWG wires. This pack contains enough housings and crimp pins (including two spare pins) for 3 female connectors.
This style of high-current connector is commonly used with the 7.2V battery packs that power many RC cars. The connector, sometimes called Tamiya or Kyosho, is keyed so that power cannot be reversed. A latch secures the connection so that it will not become disconnected.
This pack contains enough housings and crimp pins (including two spare pins) for three female connectors (we also offer a pack for the male version). The crimp pins are designed for 14- to 20-AWG wires, and we sell a crimping tool that works well with them. As an alternative, we sell a pre-crimped version of this connector with 10 cm leads.
Note: these Tamiya connectors are sometimes referred to as “male” in the RC hobby industry, so please look at the connector picture below carefully to make sure it is what you want.
| 
 | 
 | 
|  | 
| Female Tamiya plug dimensions (in mm). | 
|---|
|  | 
| Female Tamiya connector crimp pin dimensions (in mm). | 
|---|
|  | Tamiya Connector Pack, Male | 
|  | Female Crimp Pins for 0.1" Housings 100-Pack | 
|  | Crimping Tool: 0.1-1.0 mmÂ? Capacity, 16-28 AWG | 
Producent BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Polska sprzedaz@kamami.pl 22 767 36 20
Osoba odpowiedzialna BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Polska sprzedaz@kamami.pl 22 767 36 20
 Brak towaru
 Brak towaru
 Brak towaru
HK Turnigy TrackStar 10.5T Sensored Brushless Motor 3250KV (23361)
 Brak towaru
 Brak towaru
 Brak towaru
 Brak towaru
 Brak towaru
X-NUCLEO-IKS01A2 to shield z czujnikami MEMS: akcelerometrem, żyroskopem, magnetometrem, czujnikiem ciśnienia, wilgotności i temperatury. Shield przeznaczony jest do pracy z płytkami z rodziny STM32 Nucleo (złącze zgodne ze standardem Arduino UNO R3). Czujniki używają do komunikacji interfejsu I2C. Dodatkowe złącze pozwala dołączyć kolejne czujniki
 Brak towaru
Filament firmy ROSA3D wykonany z wysokiej jakości granulatu PLA. Na szpuli nawinięte jest 0,8 kg filamentu o średnicy 1,75 mm. ROSA3D PLA Starter Rubin Red
 Brak towaru
 Brak towaru
 Brak towaru
Flexiforce Pressure Sensor A401 – 10lbs, Tekscan, RoHS
 Brak towaru
 Brak towaru
 Brak towaru
Wyświetlacz matrycowy LED RGB o rozdzielczości 32 x 32 (1024 LED). DFRobot DFR0472
 Brak towaru
 
                    Tamiya Connector Pack, Female