Rain sensor consisting of a measuring module and a container. It provides users with information about the precipitation value in millimeters and system operation time via UART and I2C interfaces. DFRobot SEN0575
List of products by brand DFRobot
There are 730 products.
Gravity: Formaldehyde (HCHO) Sensor is a module for measuring the concentration of formaldehyde (methane) in the air. It can be supplied with voltage in the range of 3.3 ... 6V. DFRobot SEN0231
Module with a bistable button and red LED backlight. The board is equipped with a Gravity connector and communicates via a digital interface. DFRobot DFR0785-R
This is a mounting bracket designed for our URM ultrasonic sensor series.It is fully compatible with URM37 and URM04. You can also have this item with only 300 reward points. DF-FIT0006
A pin expander designed for Raspberry Pi Pico boards. It is equipped with a standard female connector and two sets (male and female) of 2x20 pins. DFRobot DFR0836
The arduino turbidity sensor detects water quality by measuring level of turbidity. It is able to detect suspended particles in water by measuring the light transmittance and scattering rate which changes with the amount of total suspended solids (TSS) in water. SEN0189
Disposable biomedical electrodes that allow you to perform experimental ECG measurements. DFRobot FIT0510
Module with an analog gas sensor. It allows you to measure the concentration of NO, NO2 and H2. DFRobot SEN0441
Module with hydrogen sulphide sensor made in MEMS technology. It allows gas detection in the range of 0.5 to 50 ppm and has an analog output. DFRobot SEN0568
Module with barcode and QR scanner. It allows you to read one-dimensional and two-dimensional codes and communicates via the I2C and UART interface. DFRobot SEN0486
7" Capacitive Touch Panel Overlay for LattePanda V1.0 IPS Display
Photoelectric liquid level sensor FS-IR02 in a set with a Gravity adapter. DFRobot SEN0205
A magnetic latching relay that features low power consumption and quiet operation. It allows switching of signals up to 36 V and 10 A. It remains in the last position it was in before power was lost. DFRobot DFR0996
Evaluation set for IoT applications. Rich set of equipment in such peripheral systems as WiFi, OLED display, headphones, microphone, sensors (temperature, humidity, motion, pressure) make it a complete tool that will be used in many projects. DFRobot DFR0512
A small DC - DC boost module that converts a 0.9..5V power source to standard 5V, making it capable of supplying power to an Arduino microcontroller and other small electronic devices that use a 5v input. It integrates a PFM DC-DC boost control chip. FIT0471
AB two-phase pulse wave, measured by two infrared reflective sensor. These two sensor pulse waveform is close to a phase difference of 90 degrees, through the AB two-phase lead and lag of the waveform judged wheel forward rotation or the reverse. SEN0116
An integrated data acquisition module that includes functions such as data display, automatic sensor recognition and calibration, data storage, RTC clock and data conversion to make data acquisition more convenient and efficient. DFRobot DFR0999
A module with an acceleration and rotational speed sensor based on the ICG-20660L system. It communicates via the I2C or SPI interface. DFRobot SEN0443
Bright white SMD 3528 LED module. DFRobot DFR0438
(DRI0009) 2A Motor Shield For Arduino