Order and pay in
for same day shipping
Oscilloscope probe with BNC plug with 100MHz bandwidth. Uni-T UT-P04
Programmable, linear laboratory power supply with adjustable supply...
Evaluation kit equipped with Xilinx Artix 7 XC7A35T-1C FPGA chip and 256...
The evaluation kit is equipped with the Lattice iCE40 HX FPGA chip. The...
The expansion board is designed to work with Alchitry Au and Alchitry...
Prototype board designed to work with Alchitry Au and Alchitry Cu. There...
Module with a button and green LED backlight. Controlled by the I2C...
USB port isolator based on the ADUM3160 chip. The device has a rated...
The board allows you to attach cables to the microSD / TF card line. Supply voltage from 2.7 to 3.6 V. Polol 2597
The board outputs the lines of the microSD card , so it can be connected via SPI l. The module supply voltage and the logic level of the digital lines range from 2.7 to 3.6 V, in order to use the module with 5 V systems it is necessary to use a logic level converter , you can also use a ready module with a built-in stabilizer and converter . The 2.54mm pitch leads allow the module to be placed in the contact plate.
| GND |
|VDD||Plus power (2.7 V to 3.6 V for most microSD cards)|
|CD||The card detection line in the slot. This line is high when the card is inserted and low when there is no card in the slot|
|DI||Data input (MOSI)||CMD||CMD line of the SDIO interface|
|DOWN||Data output (MISO)||Dat0||Data0 line of the SDIO interface|
|SCLK||Clock line||CLK||Clock line|
|CS||Line selection line (the line must be low to allow communication with the card)||DAT3||Data3 line of the SDIO interface|
|- / IRQ||Break line||DAT1 / IRQ|| Data1 line of the SDIO interface |
|-||-||DAT2||Data2 line of the SDIO interface|