Pmod I2S2 (410-379) - module with stereo input and audio output

Class D digital audio amplifier with Bluetooth module. It has two channels with a power of 50 W and can work with speakers from 4 to 8 Ω. It is powered with the voltage in the range from 9 to 24 V. NS-01G

Audio player with HiFi amplifier in aluminum housing. It allows you to play files from USB memory, SD card, via the audio connector and Bluetooth. It has a built-in FM receiver

Module with an AB class amplifier based on the Boomer® LM4853 system. It can work in two modes: mono (power 1.5 W, load 4 Ω) or stereo (power 300 mW, load 8 Ω). It has a potentiometer for power control and gain control for the left and right channel. SparkFun DEV-14475

This small breakout board couples an Electret microphone (100Hz–10kHz) with a 60x mic preamplifier to amplify the sounds of voice, claps, door knocks or any sounds loud enough to be picked up by a microcontroller’s analog-to-digital converter. Each breakout comes fully assembled and works from 2.7V up to 5.5V. BOB-12758

SJ2038 digital stereo audio amplifier module. The system allows you to connect two speakers with an impedance from 4 to 8 Ω and a power of 3.5 W

Audio module with speakers designed to work with the Raspberry Pi Pico. Waveshare Pico-Audio

The module is based on the Si4703 FM tuner system. Supports wave reception in a wide frequency range from 76 to 108 MHz. It allows you to read RDS information. SparkFun BOB-11083

Class AB audio amplifier with three output channels. It can be powered with AC voltage from 8 to 18 V and has two outputs with a power of 18 W (left and right) and one with a power of 20 W (bass)

The audio level indicator module with a JST PH 2.0mm connector is a versatile device that makes monitoring audio levels much easier while being easy to install and use.

A set with an audio amplifier with a power of 350 W dedicated to the bass column (subwoofer)

Speech recognition module with LD3320 chip, STC11 microcontroller, microphone and loudspeaker output. The board communicates via the UART interface

The module with a digital stereo audio amplifier is equipped with Bluetooth communication. The system allows you to connect two speakers with an impedance from 4 Ω to 8 Ω and a power of 15 W per channel

Bluetooth audio receiver module in the set with a 3.5 mm Jack adapter. It enables wireless transmission of sounds. It is equipped with a 3.5 mm audio jack, microUSB socket and control buttons

TEA2025B class D stereo digital audio amplifier module. The system allows you to connect two speakers with an impedance from 4 to 16 Ω and a power of 3 W each

Audio module based on a 32-bit PCM5102A DAC converter intended for cooperation, among others with Raspberry Pi minicomputers. Communication via the I2S interface. GY-PCM5102

Gravity: Voice Recorder Module is a sound recording module powered by 5V voltage. It can store sounds up to 10 seconds long. DFRobot SEN0197