Order and pay in
for same day shipping
ZeroPi is a FriendlyELEC single board computer with Allwinner H3 and...
Module with the MCP9600 amplifier designed to work with a K-type...
Heat shrink tube for electrical and mechanical insulation, diameter...
The MIMXRT1062DVL6A Processor Evaluation Kit, which runs up to 600 MHz,...
RTL8370N-VB-CG, high-performance 8-port Gigabit Ethernet switch, LQFP128
LT8911EXB, MIPI DSI/CSI Bridge to eDP, QFN48
Capacitive proximity sensor with PNP NO output. It can detect the...
A4952ELYTR-T, Full-Bridge DMOS PWM Motor Drivers, 40V, 2A, MSOP-10
The FS90R is a micro servo that has been built by FEETECH (formerly known as Fitec) specifically for continuous rotation, offering an inexpensive and easy way to get your small turret spinning or miniature robot moving, especially when paired with our 60×8mm wheels designed specifically for this servo. Pololu 2820
|Rozmiar serwa (seria)||Micro|
|Prędkość kątowa||130 RPM|
|Praca ciągła 360°||Nie|
|Power supply voltage||4,8 - 6 V|
Key specs at 6 V: 130 RPM (no-load), 21 oz-in (1.5 kg-cm), 9 g
The FS90R is a micro-sized servo that has been built by FEETECH (formerly known as Fitec) specifically for continuous rotation. At 6V, it has a maximum rotation speed of around 130 RPM (no-load) and can produce up to 21 oz-in (1.5 kg-cm) of torque. The servo can be controlled using a direct connection to a single microcontroller I/O line without any additional electronics, which makes it a great miniature actuator for beginner robotics projects; just throw on a pair of wheels and your robot is ready to roll!
The FS90R continuous rotation servo converts standard RC servo position pulses into continuous rotation speed. The default rest point is 1.5 ms, but this can be adjusted by using a small screwdriver to turn the middle-point adjustment potentiometer. Pulse widths above the rest point result in counterclockwise rotation, with speed increasing as the pulse width increases; pulse widths below the rest point result in clockwise rotation, with speed increasing as the pulse width decreases.
The servo has a 8″ (200 mm) lead that is terminated with a JR-style connector and includes additional servo horns and mounting hardware.