NetFPGA-1G-CML Kintex-7 FPGA Development Board - ACADEMIC

ATTENTION! This product is for academic recipients (students and academic teachers) only!

After the ordering, please send us by e-mail the data listed below:

• the name and last name
• position (student, teacher)
• e-mail (with the University domain)
• University name
• Facultie / Section
• University address
• University phone no.
• Notice! Students must send a copy of University Identity Card (by e-mail)

Description

The NetFPGA-1G-CML is a versatile, low cost network hardware development platform featuring a Xilinx Kintex-7 XC7K325T FPGA and includes four Ethernet interfaces capable of negotiating up to 1 GB/s connections. 512 MB of 800 MHz DDR3 can support high-throughput packet buffering while 4.5 MB of QDRII+ can maintain low-latency access to high demand data, like routing tables. Rapid boot configuration is supported by a 128 MB BPI Flash, which is also available for non-volatile storage applications. The standard PCIe form factor supports high speed x4 Gen 2 interfacing. The FMC carrier connector provides a convenient expansion interface for extending card functionality via Select I/O and GTX serial interfaces. The FMC connector can support SATA-II data rates for network storage applications. The FMC connector can also be used to extend functionality via a wide variety of other cards designed for communication, measurement, and control.

The NetFPGA-1G-CML is designed to support the Stanford NetFPGA architecture with reference designs available through the NetFPGA GitHub Organization (http://www.github.com/cmlab/netfpga-1g-cml/wiki). It is fully compatible with Xilinx Vivado and ISE Design Suites as well as the Xilinx SDK for embedded software design.

Features:

• Xilinx Kintex-7 XC7K325T-1FFG676 FPGA 
  
• X4 Gen 2 PCI Express
  
• 1-Gbit BPI Flash 
  
• SD card slot 
  
• Real time clock 
  
• Crypto-authentication chip 
  
• Can be powered inside or outside a PC using a standard ATX power supply with PCIe 6 pin or 6pin+2 connector. Please refer to reference manual for more detail 
  
• X16 4.5 MB QDRII+ static RAM (450 MHz) 
  
• X8 512 MB DDR3 dynamic RAM (800 MHz) 
  
• Low-jitter 200 MHz oscillator 
  
• Four 10/100/1000 Ethernet PHYs with RGMII 
  
• 32-bit PIC microcontroller
  
• USB microcontroller
• Four on-board LEDs and four onboard general-purpose buttons
• High pin count FMC connector (VITA 57) with 100 Select-IO and 4 GTX serial pairs
• Two Pmod ports

• Technical documentation of the product (1,15 MB)
• Manufacturer website