Shielded FTP category 6 Ethernet network cable with RJ45 plugs. Lanberg PCF6-10CC-0150-W

WiFi module based on ESP8266. The module has a built-in antenna and USB-UART converter. The module can be programmed in Lua (under the control of the NodeMCU firmware) or in the Arduino environment. 10 GPIO lines are available which each can be configured to work as PWM, I2C.

Two-channel DC motor driver powered with the voltage from 2.5 to 12 V with a maximum continuous current of 0.8 A per channel. It can control a bipolar stepper motor

ARM Cortex-M0 CPU, 32kB Flash, 4kB RAM, 1xUART, 1xI2C, 1xSPI, ADC, LQFP32, STM, RoHS

Unshielded UTP category 6 Ethernet network cable with RJ45 plugs. Lanberg PCU6-10CC-0050-G

Bluetooth audio receiver module that allows wireless transmission of sounds. It is equipped with a PCB antenna and a 3.5 mm Jack audio connector

Unshielded UTP category 6 Ethernet network cable with RJ45 plugs. Lanberg PCU6-10CC-0300-G

ARM Cortex-M0+ MCU, Low power, 64kB Flash, 8kB RAM, 2xUSART, 2xI2C, 2xSPI, ADC, STM, LQFP64, RoHS

ARK terminal connector spring 6-pin, pitch 5.00 mm, non-detachable

Class D mono digital audio amplifier module PAM8302. The system allows you to connect one loudspeaker with an impedance from 4 to 8 Ω and a power of 2.5 W

A set of EC2 connectors (male plug and female socket with contacts) with a maximum forward current of 15 A. It works well as a battery connector or a power connector in RC models. Amass EC2

0.4 A Dual H-Bridge Motor Driver IC, QFN16, Freescale, RoHS

The TPA2005D1DGN is a Class D audio power amplifier from Texas Instruments, offering up to 1.45 W of output power on a single channel, ideal for portable audio devices such as smartphones and Bluetooth speakers. It operates over a voltage range of 2.5V to 5.5V, providing high power efficiency and low distortion, and its compact MSOP-8 package facilitates integration into small projects.

Laser sensor of air pollution with particles PM1,0, PM2.5 and PM10. It allows for precise analysis of the amount of pollutants in the environment, has small dimensions and a built-in silent transfer fan. Data is output to the UART interface. PMS3003

Toggle switch, two-position with a red cover and LED backlight. It can switch voltage up to 12 V and current up to 20 A

The cable allows you to attach a USB device (eg keyboard, mouse, Flash memory) to the device with microUSB OTG connector. The cord has a length of 14cm

Connector for connecting the 16-pin tape with 0.5 mm pitch to the printed circuit board