Best sellers
There are 16467 products.
8-digit, 8-segment LED display module with 16-level brightness adjustment. Communication via the I2C interface. DFRobot DFR0646-R
Touch keyboard module with 4 buttons based on the TTP224 system. It is equipped with a connector with derived signals and 4 LEDs signaling the state of each button
Set of 5 lenses with CS-Mount. Designed to work with the Raspberry Pi HQ camera. ArduCAM LK004
3-color e-Paper display with a diagonal of 2.13" and a resolution of 212x104 px. SPI interface. No PCB. Waveshare 2.13inch e-Paper (B)
TPL5110 external counter module to turn on a project after a set time and save energy. The TPL5110\'s delay is configurable with resistors ranging from 100 ms to two hours. SparkFun PRT-15353
Precision screwdriver set
M5Stack series development kit equipped with ESP32 chip. It has a built-in microphone and is dedicated to applications that require speech recognition. M5Stack K117
Self-priming diaphragm pump with medium flow capacity. It is powered with the voltage of 12 V
Small metal gear motor, 60 RPM speed, 6V operating voltage. GA12-N20-0013
Set of 10 HEX spherical hex keys.
The electronic timer switch with memory back-up function allows you to program 10 programs of on / off control with an accuracy of one minute. # 72-010
LVDS to HDMI converter module with one LVDS connector
CS-Mount lens. 16 mm focal length, 24° FoV, manual focus and adjustable aperture. Designed to work with the Raspberry Pi HQ camera. ArduCAM LN050
Precision screwdriver set 7 pieces.
32-bit microcontroller from the STM32G0 family with ARM Cortex-M0 + core, 128kB Flash memory, 36kB RAM, up to 64MHz timing and I2C, SPI, UART / USART interfaces, LIN, IrDA, I2S, DMA, Motor Control PWM, Temp Sensor in LQFP64 housing. STMicroelectronics STM32G081RBT6
The module with 4 relays is designed for the M5Stack sets. It allows you to control devices with an operating voltage of up to 250 V AC and a current of up to 10 A or a voltage of 28 V DC and a current of 10 A. M5Stack U097
Development board equipped with ATSAMD21G18 microcontroller. It has 30 I/O lines, including SERCOM interfaces and 14 analog inputs. Compatible with Arduino. SparkFun DEV-13672
BMS module for six Li-Ion cells with a voltage of 22.2 V. It has the function of charging, discharging and over-discharge protection. The cells can be discharged with a continuous current of up to 14 A
Miniature, 12V brush DC motor with metal gear and 15.25:1 gear ratio. It has a cross section of 10 × 12 mm, and the D-shaped output shaft with a length of 9 mm and a diameter of 3 mm. Pololu 4786
Set of 10 cables, 30 cm long, for analog sensors compatible with the Gravity standard. DFRobot FIT0031