- Out-of-Stock

MODULE FOUR LED DISPLAY 5x7 - PLATE PCB
Prema Semiconductor produced PR4010 integrated circuits, which greatly simplify the control of LED lighting components. It is a 10-bit register with serial input and parallel outputs. Built-in latch latches allow you to avoid flickering of the LEDs during data recording. Most important, however, is the fact that the manufacturer has embedded in the structure of the system current sources with a maximum load current of a single output up to 10 mA (flowing through the LED from the "+" power), determined by a single resistor switched between ground and the BRT input. This frees the designer from the necessity to use resistors that determine the output current. The applied solution assures the user that eg each segment of the display will flow the same current and thus all will shine with the same intensity. This is very important when using matrix displays, e.g. 5 × 7 pixels.
The device is particularly recommended for computer system designers
Selected parameters:
A version with a set of independent components is available
A detailed description in EP 8/10
Download
The case is dedicated to the computing cluster based on the Raspberry Pi or Jetson Nano. Waveshare PI-CLUSTER-CASE
No product available!
Thermopad, thermo-adhesive tape, double-sided adhesive 20mm x 130mm x 3mm, 6W / mK, AG Thermopiles, RoHS
No product available!
The module with the ACS70331 current sensor with a direct current measuring range up to 2,5 A. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020652
No product available!
No product available!
Wired mouse with a precise optical sensor. It has a button to change the resolution in four levels: 800/1200/1600/2400 DPI. 1.8m cable with USB plug. Natec NMY-0667
No product available!
No product available!
Male terminal block, angled, 8-pin. Pitch 3.5mm. Height 9.2mm. KF2EDGR
No product available!
Akyga power cord, IEC C7 250V / 50Hz, 1.5 m long
No product available!
The SparkFun micro:bit Breakout is a board that connects to the BBC micro:bit and expands the capabilities of the development platform by providing access to more pins and allowing for connections to the I2C and SPI buses. This breakout board for the micro:bit’s edge connector allows to connect the micro:bit to breadboards and other sensors, motors, LEDs and more! BOB-13989
No product available!
What is it about marble runs that makes them so compelling? Kids (and adults!) can watch marbles going down a track, passing through various obstacles, for hours on end. Marble runs are fascinating, they grab our attention, and yet they\'re also relaxing. Marble runs and races have become an unexpected YouTube phenomenon, with thousands of videos racking up millions of views. You choose a marble to watch, to cheer for, you wonder which path it will take, you put yourself in the marble\'s place, imagining that you are right there with the glass ball, going on a marvelous, unknown journey, with twists and turns and surprises around every corner. UGears 70156
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
Camera with a resolution of 5 MPx with a USB interface. Equipped with an OV5648 CMOS sensor with a wide angle lens with a 90° angle of view. ArduCAM UB0233
No product available!
MODULE FOUR LED DISPLAY 5x7 - PLATE PCB