ZYBO Zynq-7000 ARM/FPGA SoC Trainer Board (410-279)

Name: ZYBO Zynq-7000 ARM/FPGA SoC Trainer Board (410-279)
Brand: Digilent
SKU: 558131

ID: 558131

Digilent ZYBO SoC platform powered by Xilinx Zynq Z-7010 with a dual-core ARM® Cortex-A9 processor and an Xilinx 7-series FPGA. 410-279

Retired

Kamami is the official distributor of Digilent FPGA kits, modules and measurement tools. All products of this brand in our offer are original and come directly from the manufacturer.

Description

The Zybo (Zynq™ Board) is a feature-rich, ready-to-use, entry-level embedded software and digital circuit development platform built around the smallest member of the Xilinx Zynq-7000 family, the Z-7010. The Z-7010 is based on the Xilinx^® All Programmable System-on-Chip (AP SoC) architecture, which tightly integrates a dual-core ARM Cortex-A9 processor with Xilinx 7-series field programmable gate array (FPGA) logic. When coupled with the rich set of multimedia and connectivity peripherals available on the Zybo, the Zynq Z-7010 can host a whole system design. The on-board memories, video and audio I/O, dual-role USB, Ethernet and SD slot will have your design up-and-ready with no additional hardware needed. Additionally, six Pmod connectors are available to put any design on an easy growth path.

The Zybo provides an ultra-low cost alternative to the ZedBoard for designers that don't require the high-density I/O of the FMC connector, but still wish to leverage the massive processing power and extensibility of the Zynq AP SoC architecture.

Features

Xilinx Zynq-7000 (XC7Z010-1CLG400C)
28,000 logic cells
240 KB Block RAM
80 DSP slices
On-chip dual channel, 12-bit, 1 MSPS analog-to-digital converter (XADC)
650 MHz dual-core Cortex™-A9 processor
On-board JTAG programming and UART to USB converter
DDR3 memory controller with 8 DMA channels
512 MB x32 DDR3 w/ 1050Mbps bandwidth
128 Mb Serial Flash w/ QSPI interface
microSD slot (supports Linux file system)
High-bandwith peripheral controllers: 1G Ethernet, USB 2.0, SDIO
Low-bandwidth peripheral controller: SPI, UART, I2C
Dual-role (Source/Sink) HDMI port
16-bits per pixel VGA output port
Trimode (1Gbit/100Mbit/10Mbit) Ethernet PHY
OTG USB 2.0 PHY (supports host and device)
External EEPROM (programmed with 48-bit globally unique EUI-48/64™ compatible identifier)
Audio codec with headphone out, microphone and line in jacks
GPIO: 6 pushbuttons, 4 slide switches, 5 LEDs
Six Pmod ports (1 processor-dedicated, 1 dual analog/digital)